On Tue, Dec 03, 2019 at 11:08:24PM +1030, Andrew Jeffery wrote:
> The currently interrupts are configured after the channel was enabled.
How about:
The interrupts were configured after the channel was enabled, configure
them before so they will work.
-corey
>
> Signed-off-by: Andrew Jeffery <andrew@xxxxxxxx>
> Reviewed-by: Joel Stanley <joel@xxxxxxxxx>
> Reviewed-by: Haiyue Wang <haiyue.wang@xxxxxxxxxxxxxxx>
> ---
> drivers/char/ipmi/kcs_bmc_aspeed.c | 7 ++++---
> 1 file changed, 4 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/char/ipmi/kcs_bmc_aspeed.c b/drivers/char/ipmi/kcs_bmc_aspeed.c
> index 3c955946e647..e3dd09022589 100644
> --- a/drivers/char/ipmi/kcs_bmc_aspeed.c
> +++ b/drivers/char/ipmi/kcs_bmc_aspeed.c
> @@ -268,13 +268,14 @@ static int aspeed_kcs_probe(struct platform_device *pdev)
> kcs_bmc->io_inputb = aspeed_kcs_inb;
> kcs_bmc->io_outputb = aspeed_kcs_outb;
>
> + rc = aspeed_kcs_config_irq(kcs_bmc, pdev);
> + if (rc)
> + return rc;
> +
> dev_set_drvdata(dev, kcs_bmc);
>
> aspeed_kcs_set_address(kcs_bmc, addr);
> aspeed_kcs_enable_channel(kcs_bmc, true);
> - rc = aspeed_kcs_config_irq(kcs_bmc, pdev);
> - if (rc)
> - return rc;
>
> rc = misc_register(&kcs_bmc->miscdev);
> if (rc) {
> --
> git-series 0.9.1
