Re: [linux-sunxi] [PATCH 1/3] arm64: dts: allwinner: a64: olinuxino: Fix eMMC supply regulator

[Stefan Mavrodiev <stefan@xxxxxxxxxx>]

On 11/29/19 11:26 AM, Chen-Yu Tsai wrote:
> On Fri, Nov 29, 2019 at 5:14 PM Stefan Mavrodiev <stefan@xxxxxxxxxx> wrote:
> > A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple
> > jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different
> > for boards with and without eMMC.
> >
> > This is not a big issue for DDR52 mode, however the eMMC will not work in
> > HS200/HS400, since these modes explicitly requires 1.8V.
> >
> > Signed-off-by: Stefan Mavrodiev <stefan@xxxxxxxxxx>
> > ---
> >   arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts | 4 ++--
> >   1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
> > index 96ab0227e82d..7d135decbd53 100644
> > --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
> > +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
> > @@ -14,8 +14,8 @@
> >   &mmc2 {
> >          pinctrl-names = "default";
> >          pinctrl-0 = <&mmc2_pins>;
> > -       vmmc-supply = <&reg_dcdc1>;
> > -       vqmmc-supply = <&reg_dcdc1>;
> > +       vmmc-supply = <&reg_eldo1>;
> If I'm reading the schematics correctly, VCC on the eMMC is from 3.3V.
> This corresponds to the vmmc-supply property. So you shouldn't change it.

My bad. Don't know how I've missed that.

Stefan

> > +       vqmmc-supply = <&reg_eldo1>;
> vqmmc-supply is from the VCC-PC rail, which is the one you say is triple-
> jumpered. So this change makes sense.
>
> ChenYu