Hi Vignesh On Fri, Nov 8, 2019 at 10:20 PM Vignesh Raghavendra <vigneshr@xxxxxx> wrote: > > TI's J721e SoC has a Cadence UFS IP with a TI specific wrapper. This is > a minimal driver to configure the wrapper. It releases the UFS slave > device out of reset and sets up registers to indicate PHY reference > clock input frequency before probing child Cadence UFS driver. > > Signed-off-by: Vignesh Raghavendra <vigneshr@xxxxxx> > --- Reviewed-by: Alim Akhtar <alim.akhtar@xxxxxxxxxxx> > > v3: > Fix macros to have TI_* prefix > > > v2: No change > > drivers/scsi/ufs/Kconfig | 10 ++++ > drivers/scsi/ufs/Makefile | 1 + > drivers/scsi/ufs/ti-j721e-ufs.c | 90 +++++++++++++++++++++++++++++++++ > 3 files changed, 101 insertions(+) > create mode 100644 drivers/scsi/ufs/ti-j721e-ufs.c > > diff --git a/drivers/scsi/ufs/Kconfig b/drivers/scsi/ufs/Kconfig > index 0b845ab7c3bf..d14c2243e02a 100644 > --- a/drivers/scsi/ufs/Kconfig > +++ b/drivers/scsi/ufs/Kconfig > @@ -132,6 +132,16 @@ config SCSI_UFS_HISI > Select this if you have UFS controller on Hisilicon chipset. > If unsure, say N. > > +config SCSI_UFS_TI_J721E > + tristate "TI glue layer for Cadence UFS Controller" > + depends on OF && HAS_IOMEM && (ARCH_K3 || COMPILE_TEST) > + help > + This selects driver for TI glue layer for Cadence UFS Host > + Controller IP. > + > + Selects this if you have TI platform with UFS controller. > + If unsure, say N. > + > config SCSI_UFS_BSG > bool "Universal Flash Storage BSG device node" > depends on SCSI_UFSHCD > diff --git a/drivers/scsi/ufs/Makefile b/drivers/scsi/ufs/Makefile > index 2a9097939bcb..94c6c5d7334b 100644 > --- a/drivers/scsi/ufs/Makefile > +++ b/drivers/scsi/ufs/Makefile > @@ -11,3 +11,4 @@ obj-$(CONFIG_SCSI_UFSHCD_PCI) += ufshcd-pci.o > obj-$(CONFIG_SCSI_UFSHCD_PLATFORM) += ufshcd-pltfrm.o > obj-$(CONFIG_SCSI_UFS_HISI) += ufs-hisi.o > obj-$(CONFIG_SCSI_UFS_MEDIATEK) += ufs-mediatek.o > +obj-$(CONFIG_SCSI_UFS_TI_J721E) += ti-j721e-ufs.o > diff --git a/drivers/scsi/ufs/ti-j721e-ufs.c b/drivers/scsi/ufs/ti-j721e-ufs.c > new file mode 100644 > index 000000000000..5216d228cdd9 > --- /dev/null > +++ b/drivers/scsi/ufs/ti-j721e-ufs.c > @@ -0,0 +1,90 @@ > +// SPDX-License-Identifier: GPL-2.0 > +// > +// Copyright (C) 2019 Texas Instruments Incorporated - http://www.ti.com/ > +// > + > +#include <linux/clk.h> > +#include <linux/io.h> > +#include <linux/kernel.h> > +#include <linux/module.h> > +#include <linux/of_platform.h> > +#include <linux/platform_device.h> > +#include <linux/pm_runtime.h> > + > +#define TI_UFS_SS_CTRL 0x4 > +#define TI_UFS_SS_RST_N_PCS BIT(0) > +#define TI_UFS_SS_CLK_26MHZ BIT(4) > + > +static int ti_j721e_ufs_probe(struct platform_device *pdev) > +{ > + struct device *dev = &pdev->dev; > + unsigned long clk_rate; > + void __iomem *regbase; > + struct clk *clk; > + u32 reg = 0; > + int ret; > + > + regbase = devm_platform_ioremap_resource(pdev, 0); > + if (IS_ERR(regbase)) > + return PTR_ERR(regbase); > + > + pm_runtime_enable(dev); > + ret = pm_runtime_get_sync(dev); > + if (ret < 0) { > + pm_runtime_put_noidle(dev); > + return ret; > + } > + > + /* Select MPHY refclk frequency */ > + clk = devm_clk_get(dev, NULL); > + if (IS_ERR(clk)) { > + dev_err(dev, "Cannot claim MPHY clock.\n"); > + return PTR_ERR(clk); > + } > + clk_rate = clk_get_rate(clk); > + if (clk_rate == 26000000) > + reg |= TI_UFS_SS_CLK_26MHZ; > + devm_clk_put(dev, clk); > + > + /* Take UFS slave device out of reset */ > + reg |= TI_UFS_SS_RST_N_PCS; > + writel(reg, regbase + TI_UFS_SS_CTRL); > + > + ret = of_platform_populate(pdev->dev.of_node, NULL, NULL, > + dev); > + if (ret) { > + dev_err(dev, "failed to populate child nodes %d\n", ret); > + pm_runtime_put_sync(dev); > + } > + > + return ret; > +} > + > +static int ti_j721e_ufs_remove(struct platform_device *pdev) > +{ > + of_platform_depopulate(&pdev->dev); > + pm_runtime_put_sync(&pdev->dev); > + > + return 0; > +} > + > +static const struct of_device_id ti_j721e_ufs_of_match[] = { > + { > + .compatible = "ti,j721e-ufs", > + }, > + { }, > +}; > + > +static struct platform_driver ti_j721e_ufs_driver = { > + .probe = ti_j721e_ufs_probe, > + .remove = ti_j721e_ufs_remove, > + .driver = { > + .name = "ti-j721e-ufs", > + .of_match_table = ti_j721e_ufs_of_match, > + }, > +}; > +module_platform_driver(ti_j721e_ufs_driver); > + > +MODULE_AUTHOR("Vignesh Raghavendra <vigneshr@xxxxxx>"); > +MODULE_DESCRIPTION("TI UFS host controller glue driver"); > +MODULE_LICENSE("GPL v2"); > -- > 2.24.0 > -- Regards, Alim
