On Tue, 12 Nov 2019 at 15:20, Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx> wrote:
>
> From: Vladimir Oltean <olteanv@xxxxxxxxx>
>
> On the LS1021A-TSN board, the 2 Atheros AR8031 PHYs for eth0 and eth1
> have interrupt lines connected to the shared IRQ2_B LS1021A pin.
>
> Switching to interrupts offloads the PHY library from the task of
> polling the MDIO status and AN registers (1, 4, 5) every second.
>
> Unfortunately, the BCM5464R quad PHY connected to the switch does not
> appear to have an interrupt line routed to the SoC.
>
> Signed-off-by: Vladimir Oltean <olteanv@xxxxxxxxx>
> Signed-off-by: Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx>
> ---
> arch/arm/boot/dts/ls1021a-tsn.dts | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/arch/arm/boot/dts/ls1021a-tsn.dts b/arch/arm/boot/dts/ls1021a-tsn.dts
> index 5b7689094b70..135d36461af4 100644
> --- a/arch/arm/boot/dts/ls1021a-tsn.dts
> +++ b/arch/arm/boot/dts/ls1021a-tsn.dts
> @@ -203,11 +203,15 @@
> /* AR8031 */
> sgmii_phy1: ethernet-phy@1 {
> reg = <0x1>;
> + /* SGMII1_PHY_INT_B: connected to IRQ2, active low */
> + interrupts-extended = <&extirq 2 IRQ_TYPE_EDGE_FALLING>;
> };
>
> /* AR8031 */
> sgmii_phy2: ethernet-phy@2 {
> reg = <0x2>;
> + /* SGMII2_PHY_INT_B: connected to IRQ2, active low */
> + interrupts-extended = <&extirq 2 IRQ_TYPE_EDGE_FALLING>;
> };
>
> /* BCM5464 quad PHY */
> --
> 2.23.0
>
+netdev and Andrew for this patch, since the interrupt polarity caught
his attention in v1.
