Hi Tomer, On Wed, 2019-11-06 at 16:53 +0200, Tomer Maimon wrote: > This patch set adds reset controller support > for the Nuvoton NPCM Baseboard Management Controller (BMC). > > Apart of controlling all NPCM BMC reset module lines the NPCM reset driver > support NPCM BMC software reset to restarting the NPCM BMC. > > Supporting NPCM USB-PHY reset as follow: > > NPCM BMC USB-PHY connected to two modules USB device (UDC) and USB host. > > If we will restart the USB-PHY at the UDC probe and later the > USB host probe will restart USB-PHY again it will disable the UDC > and vice versa. > > The solution is to reset the USB-PHY at the reset probe stage before > the UDC and the USB host are initializing. > > NPCM reset driver tested on NPCM750 evaluation board. > > Addressed comments from:. > - Philipp Zabel > > Changes since version 4: > - Check for stored GCR string in the of_device_id->data to gain > GCR regmap access. > - Adding check if the user used undefined reset pins > in the of_xlate function. > - Remove nr_resets initialization since it of_xlate replaced > with the custom version. Thanks, all three applied to reset/next with Rob's R-b. regards Philipp
