On Kirkwood, there is only one valid pinctrl setting for GBE1. With a common SoC pinctrl node, we can now set it in the node instead of in each board file. Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@xxxxxxxxx> --- Cc: Rob Herring <robh+dt@xxxxxxxxxx> Cc: Pawel Moll <pawel.moll@xxxxxxx> Cc: Mark Rutland <mark.rutland@xxxxxxx> Cc: Ian Campbell <ijc+devicetree@xxxxxxxxxxxxxx> Cc: Kumar Gala <galak@xxxxxxxxxxxxxx> Cc: Russell King <linux@xxxxxxxxxxxxxxxx> Cc: Jason Cooper <jason@xxxxxxxxxxxxxx> Cc: Andrew Lunn <andrew@xxxxxxx> Cc: Gregory Clement <gregory.clement@xxxxxxxxxxxxxxxxxx> Cc: Thomas Petazzoni <thomas.petazzoni@xxxxxxxxxxxxxxxxxx> Cc: devicetree@xxxxxxxxxxxxxxx Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx Cc: linux-kernel@xxxxxxxxxxxxxxx --- arch/arm/boot/dts/kirkwood-openblocks_a7.dts | 2 -- arch/arm/boot/dts/kirkwood.dtsi | 2 ++ 2 files changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/kirkwood-openblocks_a7.dts b/arch/arm/boot/dts/kirkwood-openblocks_a7.dts index 1a7f18d5530d..622a3ca12c2d 100644 --- a/arch/arm/boot/dts/kirkwood-openblocks_a7.dts +++ b/arch/arm/boot/dts/kirkwood-openblocks_a7.dts @@ -207,8 +207,6 @@ ð1 { status = "okay"; - pinctrl-0 = <&pmx_ge1>; - pinctrl-names = "default"; ethernet1-port@0 { phy-handle = <ðphy1>; }; diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi index 5d412e71b9fb..fff28b71b474 100644 --- a/arch/arm/boot/dts/kirkwood.dtsi +++ b/arch/arm/boot/dts/kirkwood.dtsi @@ -320,6 +320,8 @@ reg = <0x76000 0x4000>; clocks = <&gate_clk 19>; marvell,tx-checksum-limit = <1600>; + pinctrl-0 = <&pmx_ge1>; + pinctrl-names = "default"; status = "disabled"; ethernet1-port@0 { -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html