While the common case is that the dsi controller uses an internal dphy,
accessed through the phy registers inside the dsi controller, there is
also the possibility to use a separate dphy from a different vendor.
One such case is the Rockchip px30 that uses a Innosilicon Mipi dphy,
so add the support for handling such a constellation, including the pll
also getting generated inside that external phy.
Signed-off-by: Heiko Stuebner <heiko.stuebner@xxxxxxxxxxxxxxxxxxxxx>
---
.../display/rockchip/dw_mipi_dsi_rockchip.txt | 7 ++-
.../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c | 54 ++++++++++++++++++-
2 files changed, 57 insertions(+), 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt b/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
index ce4c1fc9116c..8b25156a9dcf 100644
--- a/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
+++ b/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
@@ -8,8 +8,9 @@ Required properties:
"rockchip,rk3399-mipi-dsi", "snps,dw-mipi-dsi".
- reg: Represent the physical address range of the controller.
- interrupts: Represent the controller's interrupt to the CPU(s).
-- clocks, clock-names: Phandles to the controller's pll reference
- clock(ref) and APB clock(pclk). For RK3399, a phy config clock
+- clocks, clock-names: Phandles to the controller's and APB clock(pclk)
+ and either a pll reference clock(ref) (internal dphy) or pll clock(pll)
+ (when connected to an external phy). For RK3399, a phy config clock
(phy_cfg) and a grf clock(grf) are required. As described in [1].
- rockchip,grf: this soc should set GRF regs to mux vopl/vopb.
- ports: contain a port node with endpoint definitions as defined in [2].
@@ -18,6 +19,8 @@ Required properties:
- video port 1 for either a panel or subsequent encoder
Optional properties:
+- phys: from general PHY binding: the phandle for the PHY device.
+- phy-names: Should be "dphy" if phys references an external phy.
- power-domains: a phandle to mipi dsi power domain node.
- resets: list of phandle + reset specifier pairs, as described in [3].
- reset-names: string reset name, must be "apb".
diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
index bc073ec5c183..99ec625e0448 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
@@ -12,6 +12,7 @@
#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/of_device.h>
+#include <linux/phy/phy.h>
#include <linux/pm_runtime.h>
#include <linux/regmap.h>
@@ -223,6 +224,9 @@ struct dw_mipi_dsi_rockchip {
bool is_slave;
struct dw_mipi_dsi_rockchip *slave;
+ /* optional external dphy */
+ struct phy *phy;
+
unsigned int lane_mbps; /* per lane */
u16 input_div;
u16 feedback_div;
@@ -359,6 +363,9 @@ static int dw_mipi_dsi_phy_init(void *priv_data)
struct dw_mipi_dsi_rockchip *dsi = priv_data;
int ret, i, vco;
+ if (dsi->phy)
+ return 0;
+
/*
* Get vco from frequency(lane_mbps)
* vco frequency table
@@ -467,6 +474,27 @@ static int dw_mipi_dsi_phy_init(void *priv_data)
return ret;
}
+static void dw_mipi_dsi_phy_power_on(void *priv_data)
+{
+ struct dw_mipi_dsi_rockchip *dsi = priv_data;
+ int ret;
+
+ ret = phy_set_mode(dsi->phy, PHY_MODE_MIPI_DPHY);
+ if (ret) {
+ DRM_DEV_ERROR(dsi->dev, "failed to set phy mode: %d\n", ret);
+ return;
+ }
+
+ phy_power_on(dsi->phy);
+}
+
+static void dw_mipi_dsi_phy_power_off(void *priv_data)
+{
+ struct dw_mipi_dsi_rockchip *dsi = priv_data;
+
+ phy_power_off(dsi->phy);
+}
+
static int
dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
unsigned long mode_flags, u32 lanes, u32 format,
@@ -504,9 +532,21 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
"DPHY clock frequency is out of range\n");
}
- fin = clk_get_rate(dsi->pllref_clk);
fout = target_mbps * USEC_PER_SEC;
+ /* an external phy does have a controllable pll clk */
+ if (dsi->phy) {
+ fout = clk_round_rate(dsi->pllref_clk, fout);
+ clk_set_rate(dsi->pllref_clk, fout);
+
+ dsi->lane_mbps = target_mbps;
+ *lane_mbps = dsi->lane_mbps;
+
+ return 0;
+ }
+
+ fin = clk_get_rate(dsi->pllref_clk);
+
/* constraint: 5Mhz <= Fref / N <= 40MHz */
min_prediv = DIV_ROUND_UP(fin, 40 * USEC_PER_SEC);
max_prediv = fin / (5 * USEC_PER_SEC);
@@ -561,6 +601,8 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
static const struct dw_mipi_dsi_phy_ops dw_mipi_dsi_rockchip_phy_ops = {
.init = dw_mipi_dsi_phy_init,
+ .power_on = dw_mipi_dsi_phy_power_on,
+ .power_off = dw_mipi_dsi_phy_power_off,
.get_lane_mbps = dw_mipi_dsi_get_lane_mbps,
};
@@ -920,7 +962,15 @@ static int dw_mipi_dsi_rockchip_probe(struct platform_device *pdev)
return -EINVAL;
}
- dsi->pllref_clk = devm_clk_get(dev, "ref");
+ /* try to get a possible external dphy */
+ dsi->phy = devm_phy_optional_get(dev, "dphy");
+ if (IS_ERR(dsi->phy)) {
+ ret = PTR_ERR(dsi->phy);
+ DRM_DEV_ERROR(dev, "failed to get mipi dphy: %d\n", ret);
+ return ret;
+ }
+
+ dsi->pllref_clk = devm_clk_get(dev, dsi->phy ? "pll" : "ref");
if (IS_ERR(dsi->pllref_clk)) {
ret = PTR_ERR(dsi->pllref_clk);
DRM_DEV_ERROR(dev,
--
2.23.0
