Rob Herring <robh@xxxxxxxxxx> wrote on Tue [2019-Oct-29 08:20:09 -0500]: > On Fri, Oct 18, 2019 at 10:34:19AM -0500, Benoit Parrot wrote: > > Update Device Tree bindings for the CAL driver to use syscon to access > > the phy config register instead of trying to map it directly. > > > > Signed-off-by: Benoit Parrot <bparrot@xxxxxx> > > --- > > Documentation/devicetree/bindings/media/ti-cal.txt | 14 +++++++++----- > > 1 file changed, 9 insertions(+), 5 deletions(-) > > > > diff --git a/Documentation/devicetree/bindings/media/ti-cal.txt b/Documentation/devicetree/bindings/media/ti-cal.txt > > index ae9b52f37576..782f801b12a9 100644 > > --- a/Documentation/devicetree/bindings/media/ti-cal.txt > > +++ b/Documentation/devicetree/bindings/media/ti-cal.txt > > @@ -10,9 +10,14 @@ Required properties: > > - compatible: must be "ti,dra72-cal" > > - reg: CAL Top level, Receiver Core #0, Receiver Core #1 and Camera RX > > control address space > > -- reg-names: cal_top, cal_rx_core0, cal_rx_core1, and camerrx_control > > +- reg-names: cal_top, cal_rx_core0, cal_rx_core1 and camerrx_control > > registers > > - interrupts: should contain IRQ line for the CAL; > > +- syscon-camerrx: phandle to the device control module and offset to the > > + control_camerarx_core register > > + This node is meant to replace the "camerrx_control" reg > > + entry above but "camerrx_control" is still handled > > + for backward compatibility. > > Needs a vendor prefix and drop 'syscon'. Hmm, I had chosen this syntax based on previous examples. But I can change it. How about "ti,camerrx_control"? > > > > > CAL supports 2 camera port nodes on MIPI bus. Each CSI2 camera port nodes > > should contain a 'port' child node with child 'endpoint' node. Please > > @@ -25,13 +30,12 @@ Example: > > ti,hwmods = "cal"; > > reg = <0x4845B000 0x400>, > > <0x4845B800 0x40>, > > - <0x4845B900 0x40>, > > - <0x4A002e94 0x4>; > > + <0x4845B900 0x40>; > > reg-names = "cal_top", > > "cal_rx_core0", > > - "cal_rx_core1", > > - "camerrx_control"; > > + "cal_rx_core1"; > > interrupts = <GIC_SPI 119 IRQ_TYPE_LEVEL_HIGH>; > > + syscon-camerrx = <&scm_conf 0xE94>; > > #address-cells = <1>; > > #size-cells = <0>; > > > > -- > > 2.17.1 > >
