This enables the Broadcom uart bluetooth driver on uart0 and gives it
ownership of its gpios. In order to use this, you must enable the
following kconfig options:
- CONFIG_BT_HCIUART_BCM
- CONFIG_SERIAL_DEV
Signed-off-by: Abhishek Pandit-Subedi <abhishekpandit@xxxxxxxxxxxx>
---
arch/arm/boot/dts/rk3288-veyron.dtsi | 31 +++++++---------------------
1 file changed, 7 insertions(+), 24 deletions(-)
diff --git a/arch/arm/boot/dts/rk3288-veyron.dtsi b/arch/arm/boot/dts/rk3288-veyron.dtsi
index 7525e3dd1fc1..8c9f91ba6f57 100644
--- a/arch/arm/boot/dts/rk3288-veyron.dtsi
+++ b/arch/arm/boot/dts/rk3288-veyron.dtsi
@@ -23,30 +23,6 @@
reg = <0x0 0x0 0x0 0x80000000>;
};
- bt_activity: bt-activity {
- compatible = "gpio-keys";
- pinctrl-names = "default";
- pinctrl-0 = <&bt_host_wake>;
-
- /*
- * HACK: until we have an LPM driver, we'll use an
- * ugly GPIO key to allow Bluetooth to wake from S3.
- * This is expected to only be used by BT modules that
- * use UART for comms. For BT modules that talk over
- * SDIO we should use a wakeup mechanism related to SDIO.
- *
- * Use KEY_RESERVED here since that will work as a wakeup but
- * doesn't get reported to higher levels (so doesn't confuse
- * Chrome).
- */
- bt-wake {
- label = "BT Wakeup";
- gpios = <&gpio4 RK_PD7 GPIO_ACTIVE_HIGH>;
- linux,code = <KEY_RESERVED>;
- wakeup-source;
- };
-
- };
power_button: power-button {
compatible = "gpio-keys";
@@ -434,6 +410,13 @@
/* Pins don't include flow control by default; add that in */
pinctrl-names = "default";
pinctrl-0 = <&uart0_xfer &uart0_cts &uart0_rts>;
+
+ bluetooth {
+ compatible = "brcm,bcm43540-bt";
+ host-wakeup-gpios = <&gpio4 RK_PD7 GPIO_ACTIVE_HIGH>;
+ shutdown-gpios = <&gpio4 RK_PD5 GPIO_ACTIVE_LOW>;
+ device-wakeup-gpios = <&gpio4 RK_PD2 GPIO_ACTIVE_HIGH>;
+ };
};
&uart1 {
--
2.24.0.rc0.303.g954a862665-goog
