On 10/21/19 7:26 PM, Jeff LaBundy wrote:
Hi Guenter,
Thank you for your prompt review.
On Mon, Oct 21, 2019 at 08:38:25AM -0700, Guenter Roeck wrote:
On Sun, Oct 20, 2019 at 11:11:19PM -0500, Jeff LaBundy wrote:
This patch adds support for the Azoteq IQS620AT temperature sensor,
capable of reporting its absolute die temperature.
Signed-off-by: Jeff LaBundy <jeff@xxxxxxxxxxx>
Seems to me this might be more feasible as iio driver.
Jonathan, what do you think ?
Interestingly enough, this actually started as an iio driver; however the
"When to Use" slide of [0] made me suspect that conventional devices with
the temperature sensing element integrated on the die belong in hwmon.
I then found the highly similar ad7314, which Jonathan himself appears to
have converted from iio to hwmon. Therefore, I placed this where existing
drivers seemed to match the most, especially since the temperature sensors
in iio generally use IR or a thermocouple.
That being said, I would be happy to move this into iio so long as Jonathan
does not mind, as it would limit the blast radius of this patch series.
I don't recall why the ad7314 driver was moved. With a conversion time of 40uS
it is most definitely not a typical use case for a hwmon sensor.
Anyway, not worth arguing about. Just don't complain later. There is an
iio->hwmon bridge, but no hwmon->iio bridge, so the decision does have some
impact. Specifically, userspace will have to implement both hwmon and iio
access to handle the chip.
Guenter
