On 2019-08-29 13:30, Robert Chiras wrote:
> Currently, the MXSFB DRM driver only supports a panel. But, its output
> display signal can also be redirected to another encoder, like a DSI
> controller. In this case, that DSI controller may act like a drm_bridge.
> In order support this use-case too, this patch adds support for drm_bridge
> in mxsfb.
>
> Signed-off-by: Robert Chiras <robert.chiras@xxxxxxx>
> Tested-by: Guido Günther <agx@xxxxxxxxxxx>
Applied to the drm-misc-next branch.
--
Stefan
> ---
> drivers/gpu/drm/mxsfb/mxsfb_crtc.c | 17 +++++++++++---
> drivers/gpu/drm/mxsfb/mxsfb_drv.c | 46 +++++++++++++++++++++++++++++++++-----
> drivers/gpu/drm/mxsfb/mxsfb_drv.h | 4 +++-
> drivers/gpu/drm/mxsfb/mxsfb_out.c | 26 +++++++++++----------
> 4 files changed, 72 insertions(+), 21 deletions(-)
>
> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
> b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
> index 1242156..de09b93 100644
> --- a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
> +++ b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c
> @@ -95,8 +95,11 @@ static void mxsfb_set_bus_fmt(struct
> mxsfb_drm_private *mxsfb)
>
> reg = readl(mxsfb->base + LCDC_CTRL);
>
> - if (mxsfb->connector.display_info.num_bus_formats)
> - bus_format = mxsfb->connector.display_info.bus_formats[0];
> + if (mxsfb->connector->display_info.num_bus_formats)
> + bus_format = mxsfb->connector->display_info.bus_formats[0];
> +
> + DRM_DEV_DEBUG_DRIVER(drm->dev, "Using bus_format: 0x%08X\n",
> + bus_format);
>
> reg &= ~CTRL_BUS_WIDTH_MASK;
> switch (bus_format) {
> @@ -204,8 +207,9 @@ static dma_addr_t mxsfb_get_fb_paddr(struct
> mxsfb_drm_private *mxsfb)
>
> static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb)
> {
> + struct drm_device *drm = mxsfb->pipe.crtc.dev;
> struct drm_display_mode *m = &mxsfb->pipe.crtc.state->adjusted_mode;
> - const u32 bus_flags = mxsfb->connector.display_info.bus_flags;
> + const u32 bus_flags = mxsfb->connector->display_info.bus_flags;
> u32 vdctrl0, vsync_pulse_len, hsync_pulse_len;
> int err;
>
> @@ -229,6 +233,13 @@ static void mxsfb_crtc_mode_set_nofb(struct
> mxsfb_drm_private *mxsfb)
>
> clk_set_rate(mxsfb->clk, m->crtc_clock * 1000);
>
> + DRM_DEV_DEBUG_DRIVER(drm->dev, "Pixel clock: %dkHz (actual: %dkHz)\n",
> + m->crtc_clock,
> + (int)(clk_get_rate(mxsfb->clk) / 1000));
> + DRM_DEV_DEBUG_DRIVER(drm->dev, "Connector bus_flags: 0x%08X\n",
> + bus_flags);
> + DRM_DEV_DEBUG_DRIVER(drm->dev, "Mode flags: 0x%08X\n", m->flags);
> +
> writel(TRANSFER_COUNT_SET_VCOUNT(m->crtc_vdisplay) |
> TRANSFER_COUNT_SET_HCOUNT(m->crtc_hdisplay),
> mxsfb->base + mxsfb->devdata->transfer_count);
> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_drv.c
> b/drivers/gpu/drm/mxsfb/mxsfb_drv.c
> index e850633..497cf44 100644
> --- a/drivers/gpu/drm/mxsfb/mxsfb_drv.c
> +++ b/drivers/gpu/drm/mxsfb/mxsfb_drv.c
> @@ -101,9 +101,25 @@ static void mxsfb_pipe_enable(struct
> drm_simple_display_pipe *pipe,
> struct drm_crtc_state *crtc_state,
> struct drm_plane_state *plane_state)
> {
> + struct drm_connector *connector;
> struct mxsfb_drm_private *mxsfb = drm_pipe_to_mxsfb_drm_private(pipe);
> struct drm_device *drm = pipe->plane.dev;
>
> + if (!mxsfb->connector) {
> + list_for_each_entry(connector,
> + &drm->mode_config.connector_list,
> + head)
> + if (connector->encoder == &mxsfb->pipe.encoder) {
> + mxsfb->connector = connector;
> + break;
> + }
> + }
> +
> + if (!mxsfb->connector) {
> + dev_warn(drm->dev, "No connector attached, using default\n");
> + mxsfb->connector = &mxsfb->panel_connector;
> + }
> +
> pm_runtime_get_sync(drm->dev);
> drm_panel_prepare(mxsfb->panel);
> mxsfb_crtc_enable(mxsfb);
> @@ -129,6 +145,9 @@ static void mxsfb_pipe_disable(struct
> drm_simple_display_pipe *pipe)
> drm_crtc_send_vblank_event(crtc, event);
> }
> spin_unlock_irq(&drm->event_lock);
> +
> + if (mxsfb->connector != &mxsfb->panel_connector)
> + mxsfb->connector = NULL;
> }
>
> static void mxsfb_pipe_update(struct drm_simple_display_pipe *pipe,
> @@ -226,16 +245,33 @@ static int mxsfb_load(struct drm_device *drm,
> unsigned long flags)
>
> ret = drm_simple_display_pipe_init(drm, &mxsfb->pipe, &mxsfb_funcs,
> mxsfb_formats, ARRAY_SIZE(mxsfb_formats), NULL,
> - &mxsfb->connector);
> + mxsfb->connector);
> if (ret < 0) {
> dev_err(drm->dev, "Cannot setup simple display pipe\n");
> goto err_vblank;
> }
>
> - ret = drm_panel_attach(mxsfb->panel, &mxsfb->connector);
> - if (ret) {
> - dev_err(drm->dev, "Cannot connect panel\n");
> - goto err_vblank;
> + /*
> + * Attach panel only if there is one.
> + * If there is no panel attach, it must be a bridge. In this case, we
> + * need a reference to its connector for a proper initialization.
> + * We will do this check in pipe->enable(), since the connector won't
> + * be attached to an encoder until then.
> + */
> +
> + if (mxsfb->panel) {
> + ret = drm_panel_attach(mxsfb->panel, mxsfb->connector);
> + if (ret) {
> + dev_err(drm->dev, "Cannot connect panel: %d\n", ret);
> + goto err_vblank;
> + }
> + } else if (mxsfb->bridge) {
> + ret = drm_simple_display_pipe_attach_bridge(&mxsfb->pipe,
> + mxsfb->bridge);
> + if (ret) {
> + dev_err(drm->dev, "Cannot connect bridge: %d\n", ret);
> + goto err_vblank;
> + }
> }
>
> drm->mode_config.min_width = MXSFB_MIN_XRES;
> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_drv.h
> b/drivers/gpu/drm/mxsfb/mxsfb_drv.h
> index d975300..0b65b51 100644
> --- a/drivers/gpu/drm/mxsfb/mxsfb_drv.h
> +++ b/drivers/gpu/drm/mxsfb/mxsfb_drv.h
> @@ -27,8 +27,10 @@ struct mxsfb_drm_private {
> struct clk *clk_disp_axi;
>
> struct drm_simple_display_pipe pipe;
> - struct drm_connector connector;
> + struct drm_connector panel_connector;
> + struct drm_connector *connector;
> struct drm_panel *panel;
> + struct drm_bridge *bridge;
> };
>
> int mxsfb_setup_crtc(struct drm_device *dev);
> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_out.c
> b/drivers/gpu/drm/mxsfb/mxsfb_out.c
> index be36f4d..4eb9474 100644
> --- a/drivers/gpu/drm/mxsfb/mxsfb_out.c
> +++ b/drivers/gpu/drm/mxsfb/mxsfb_out.c
> @@ -21,7 +21,8 @@
> static struct mxsfb_drm_private *
> drm_connector_to_mxsfb_drm_private(struct drm_connector *connector)
> {
> - return container_of(connector, struct mxsfb_drm_private, connector);
> + return container_of(connector, struct mxsfb_drm_private,
> + panel_connector);
> }
>
> static int mxsfb_panel_get_modes(struct drm_connector *connector)
> @@ -76,22 +77,23 @@ static const struct drm_connector_funcs
> mxsfb_panel_connector_funcs = {
> int mxsfb_create_output(struct drm_device *drm)
> {
> struct mxsfb_drm_private *mxsfb = drm->dev_private;
> - struct drm_panel *panel;
> int ret;
>
> - ret = drm_of_find_panel_or_bridge(drm->dev->of_node, 0, 0, &panel, NULL);
> + ret = drm_of_find_panel_or_bridge(drm->dev->of_node, 0, 0,
> + &mxsfb->panel, &mxsfb->bridge);
> if (ret)
> return ret;
>
> - mxsfb->connector.dpms = DRM_MODE_DPMS_OFF;
> - mxsfb->connector.polled = 0;
> - drm_connector_helper_add(&mxsfb->connector,
> - &mxsfb_panel_connector_helper_funcs);
> - ret = drm_connector_init(drm, &mxsfb->connector,
> - &mxsfb_panel_connector_funcs,
> - DRM_MODE_CONNECTOR_Unknown);
> - if (!ret)
> - mxsfb->panel = panel;
> + if (mxsfb->panel) {
> + mxsfb->connector = &mxsfb->panel_connector;
> + mxsfb->connector->dpms = DRM_MODE_DPMS_OFF;
> + mxsfb->connector->polled = 0;
> + drm_connector_helper_add(mxsfb->connector,
> + &mxsfb_panel_connector_helper_funcs);
> + ret = drm_connector_init(drm, mxsfb->connector,
> + &mxsfb_panel_connector_funcs,
> + DRM_MODE_CONNECTOR_Unknown);
> + }
>
> return ret;
> }
