In the original design, mtk_phy_connect function will set ge_mode=1
if phy-mode is GMII(PHY_INTERFACE_MODE_GMII) and then set the correct
ge_mode to ETHSYS_SYSCFG0 register. This logic was broken after apply
mediatek PHYLINK patch(Fixes tag), the new mtk_mac_config function will
not set ge_mode=1 for GMII mode hence the final ETHSYS_SYSCFG0 setting
will be incorrect for mt7629 GMII mode. This patch add the missing logic
back to fix it.
Fixes: b8fc9f30821e ("net: ethernet: mediatek: Add basic PHYLINK support")
Signed-off-by: MarkLee <Mark-MC.Lee@xxxxxxxxxxxx>
--
v2->v3:
* no change
v1->v2:
* no change
---
drivers/net/ethernet/mediatek/mtk_eth_soc.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index c61069340f4f..703adb96429e 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -261,6 +261,7 @@ static void mtk_mac_config(struct phylink_config *config, unsigned int mode,
ge_mode = 0;
switch (state->interface) {
case PHY_INTERFACE_MODE_MII:
+ case PHY_INTERFACE_MODE_GMII:
ge_mode = 1;
break;
case PHY_INTERFACE_MODE_REVMII:
--
2.17.1
