On Sun, 6 Oct 2019 15:21:54 +0200 Lorenzo Bianconi <lorenzo@xxxxxxxxxx> wrote: > This series fixes some corner cases introduced with LSM9DS1 support and with > the one that has added wake-up event support. In particular it fixes a crash > due to missing HW FIFO support for LSM9DS1. > Moreover I introduced the missing wake-up event support for LSM6DSO/LSM6DSOX > sensor > Add missing dts documentation for wake-up event and the capability to enable it > through platformdata. > Code cleanup. Hmm. This is going to be very messy. In theory quite a few of these apply to stuff in 5.4 but I assume won't cleanly apply given other changes. You may want to think about doing backports of the important parts to 5.4. I'll apply the lot for 5.5. Thanks, Jonathan > > Lorenzo Bianconi (13): > iio: imu: st_lsm6dsx: use st_lsm6dsx_read_locked in > st_lsm6dsx_report_motion_event > iio: imu: st_lsm6dsx: add sanity check for read_fifo pointer > iio: imu: st_lsm6dsx: move irq related definitions in irq_config > iio: imu: st_lsm6dsx: do not access active-low/open-drain regs if not > supported > iio: imu: st_lsm6dsx: move bdu/boot and reset register info in > hw_settings > iio: imu: st_lsm6dsx: always check enable_reg in > st_lsm6dsx_event_setup > iio: imu: st_lsm6dsx: rely on st_lsm6dsx_update_bits_locked > configuring events > iio: imu: st_lsm6dsx: grab conf mutex in st_lsm6dsx_write_event_config > iio: imu: st_lsm6dsx: fix checkpatch warning > iio: imu: st_lsm6dsx: add wakeup_source in st_sensors_platform_data > iio: imu: st_lsm6dsx: add missing kernel documenation > dt-bindings: iio: imu: st_lsm6dsx: document missing wakeup-source > property > iio: imu: st_lsm6dsx: enable wake-up event for LSM6DSO > > .../bindings/iio/imu/st_lsm6dsx.txt | 1 + > drivers/iio/imu/st_lsm6dsx/st_lsm6dsx.h | 35 +- > .../iio/imu/st_lsm6dsx/st_lsm6dsx_buffer.c | 3 + > drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c | 588 ++++++++++++------ > .../linux/platform_data/st_sensors_pdata.h | 2 + > 5 files changed, 440 insertions(+), 189 deletions(-) >
