[PATCH 3/6] phy: tegra: xusb: Add Tegra194 support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Add support for the XUSB pad controller found on Tegra194 SoCs. It is
mostly similar to the same IP found on Tegra186, but the number of
pads exposed differs, as do the programming sequences. Because most of
the Tegra194 XUSB PADCTL registers definition and programming sequence
are the same as Tegra186, Tegra194 XUSB PADCTL can share the same
driver, xusb-tegra186.c, with Tegra186 XUSB PADCTL.

Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it
is possible for some platforms have long signal trace that could not
provide sufficient electrical environment for Gen 2 speed. This patch
introduce a new device node property "nvidia,disable-gen2" that can
be used to specifically disable Gen 2 speed for a particular USB 3.0
port so that the port can be limited to Gen 1 speed and avoid the
instability.

Signed-off-by: JC Kuo <jckuo@xxxxxxxxxx>
---
 drivers/phy/tegra/Makefile        |  1 +
 drivers/phy/tegra/xusb-tegra186.c | 77 +++++++++++++++++++++++++++++++
 drivers/phy/tegra/xusb.c          | 13 ++++++
 drivers/phy/tegra/xusb.h          |  4 ++
 4 files changed, 95 insertions(+)

diff --git a/drivers/phy/tegra/Makefile b/drivers/phy/tegra/Makefile
index 320dd389f34d..89b84067cb4c 100644
--- a/drivers/phy/tegra/Makefile
+++ b/drivers/phy/tegra/Makefile
@@ -6,4 +6,5 @@ phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_124_SOC) += xusb-tegra124.o
 phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_132_SOC) += xusb-tegra124.o
 phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_210_SOC) += xusb-tegra210.o
 phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_186_SOC) += xusb-tegra186.o
+phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_194_SOC) += xusb-tegra186.o
 obj-$(CONFIG_PHY_TEGRA194_P2U) += phy-tegra194-p2u.o
diff --git a/drivers/phy/tegra/xusb-tegra186.c b/drivers/phy/tegra/xusb-tegra186.c
index 6f3afaf9398f..4e27acf398b2 100644
--- a/drivers/phy/tegra/xusb-tegra186.c
+++ b/drivers/phy/tegra/xusb-tegra186.c
@@ -64,6 +64,13 @@
 #define  SSPX_ELPG_CLAMP_EN_EARLY(x)		BIT(1 + (x) * 3)
 #define  SSPX_ELPG_VCORE_DOWN(x)		BIT(2 + (x) * 3)
 
+#if IS_ENABLED(CONFIG_ARCH_TEGRA_194_SOC)
+#define XUSB_PADCTL_SS_PORT_CFG			0x2c
+#define   PORTX_SPEED_SUPPORT_SHIFT(x)		((x) * 4)
+#define   PORTX_SPEED_SUPPORT_MASK		(0x3)
+#define     PORT_SPEED_SUPPORT_GEN1		(0x0)
+#endif
+
 #define XUSB_PADCTL_USB2_OTG_PADX_CTL0(x)	(0x88 + (x) * 0x40)
 #define  HS_CURR_LEVEL(x)			((x) & 0x3f)
 #define  TERM_SEL				BIT(25)
@@ -635,6 +642,17 @@ static int tegra186_usb3_phy_power_on(struct phy *phy)
 
 	padctl_writel(padctl, value, XUSB_PADCTL_SS_PORT_CAP);
 
+#if IS_ENABLED(CONFIG_ARCH_TEGRA_194_SOC)
+	if (padctl->soc == &tegra194_xusb_padctl_soc && port->disable_gen2) {
+		value = padctl_readl(padctl, XUSB_PADCTL_SS_PORT_CFG);
+		value &= ~(PORTX_SPEED_SUPPORT_MASK <<
+			PORTX_SPEED_SUPPORT_SHIFT(index));
+		value |= (PORT_SPEED_SUPPORT_GEN1 <<
+			PORTX_SPEED_SUPPORT_SHIFT(index));
+		padctl_writel(padctl, value, XUSB_PADCTL_SS_PORT_CFG);
+	}
+#endif
+
 	value = padctl_readl(padctl, XUSB_PADCTL_ELPG_PROGRAM_1);
 	value &= ~SSPX_ELPG_VCORE_DOWN(index);
 	padctl_writel(padctl, value, XUSB_PADCTL_ELPG_PROGRAM_1);
@@ -894,6 +912,65 @@ const struct tegra_xusb_padctl_soc tegra186_xusb_padctl_soc = {
 };
 EXPORT_SYMBOL_GPL(tegra186_xusb_padctl_soc);
 
+#if IS_ENABLED(CONFIG_ARCH_TEGRA_194_SOC)
+static const char * const tegra194_xusb_padctl_supply_names[] = {
+	"avdd-usb",
+	"vclamp-usb",
+};
+
+static const struct tegra_xusb_lane_soc tegra194_usb2_lanes[] = {
+	TEGRA186_LANE("usb2-0", 0,  0, 0, usb2),
+	TEGRA186_LANE("usb2-1", 0,  0, 0, usb2),
+	TEGRA186_LANE("usb2-2", 0,  0, 0, usb2),
+	TEGRA186_LANE("usb2-3", 0,  0, 0, usb2),
+};
+
+static const struct tegra_xusb_pad_soc tegra194_usb2_pad = {
+	.name = "usb2",
+	.num_lanes = ARRAY_SIZE(tegra194_usb2_lanes),
+	.lanes = tegra194_usb2_lanes,
+	.ops = &tegra186_usb2_pad_ops,
+};
+
+static const struct tegra_xusb_lane_soc tegra194_usb3_lanes[] = {
+	TEGRA186_LANE("usb3-0", 0,  0, 0, usb3),
+	TEGRA186_LANE("usb3-1", 0,  0, 0, usb3),
+	TEGRA186_LANE("usb3-2", 0,  0, 0, usb3),
+	TEGRA186_LANE("usb3-3", 0,  0, 0, usb3),
+};
+
+static const struct tegra_xusb_pad_soc tegra194_usb3_pad = {
+	.name = "usb3",
+	.num_lanes = ARRAY_SIZE(tegra194_usb3_lanes),
+	.lanes = tegra194_usb3_lanes,
+	.ops = &tegra186_usb3_pad_ops,
+};
+
+static const struct tegra_xusb_pad_soc * const tegra194_pads[] = {
+	&tegra194_usb2_pad,
+	&tegra194_usb3_pad,
+};
+
+const struct tegra_xusb_padctl_soc tegra194_xusb_padctl_soc = {
+	.num_pads = ARRAY_SIZE(tegra194_pads),
+	.pads = tegra194_pads,
+	.ports = {
+		.usb2 = {
+			.ops = &tegra186_usb2_port_ops,
+			.count = 4,
+		},
+		.usb3 = {
+			.ops = &tegra186_usb3_port_ops,
+			.count = 4,
+		},
+	},
+	.ops = &tegra186_xusb_padctl_ops,
+	.supply_names = tegra194_xusb_padctl_supply_names,
+	.num_supplies = ARRAY_SIZE(tegra194_xusb_padctl_supply_names),
+};
+EXPORT_SYMBOL_GPL(tegra194_xusb_padctl_soc);
+#endif
+
 MODULE_AUTHOR("JC Kuo <jckuo@xxxxxxxxxx>");
 MODULE_DESCRIPTION("NVIDIA Tegra186 XUSB Pad Controller driver");
 MODULE_LICENSE("GPL v2");
diff --git a/drivers/phy/tegra/xusb.c b/drivers/phy/tegra/xusb.c
index 2ea8497af82a..266c08074b28 100644
--- a/drivers/phy/tegra/xusb.c
+++ b/drivers/phy/tegra/xusb.c
@@ -65,6 +65,12 @@ static const struct of_device_id tegra_xusb_padctl_of_match[] = {
 		.compatible = "nvidia,tegra186-xusb-padctl",
 		.data = &tegra186_xusb_padctl_soc,
 	},
+#endif
+#if defined(CONFIG_ARCH_TEGRA_194_SOC)
+	{
+		.compatible = "nvidia,tegra194-xusb-padctl",
+		.data = &tegra194_xusb_padctl_soc,
+	},
 #endif
 	{ }
 };
@@ -739,6 +745,13 @@ static int tegra_xusb_usb3_port_parse_dt(struct tegra_xusb_usb3_port *usb3)
 
 	usb3->internal = of_property_read_bool(np, "nvidia,internal");
 
+#if IS_ENABLED(CONFIG_ARCH_TEGRA_194_SOC)
+	if (port->padctl->soc == &tegra194_xusb_padctl_soc) {
+		usb3->disable_gen2 = of_property_read_bool(np,
+							"nvidia,disable-gen2");
+	}
+#endif
+
 	usb3->supply = devm_regulator_get(&port->dev, "vbus");
 	return PTR_ERR_OR_ZERO(usb3->supply);
 }
diff --git a/drivers/phy/tegra/xusb.h b/drivers/phy/tegra/xusb.h
index 093076ca27fd..6b71978ba15d 100644
--- a/drivers/phy/tegra/xusb.h
+++ b/drivers/phy/tegra/xusb.h
@@ -332,6 +332,7 @@ struct tegra_xusb_usb3_port {
 	bool context_saved;
 	unsigned int port;
 	bool internal;
+	bool disable_gen2;
 
 	u32 tap1;
 	u32 amp;
@@ -444,5 +445,8 @@ extern const struct tegra_xusb_padctl_soc tegra210_xusb_padctl_soc;
 #if defined(CONFIG_ARCH_TEGRA_186_SOC)
 extern const struct tegra_xusb_padctl_soc tegra186_xusb_padctl_soc;
 #endif
+#if defined(CONFIG_ARCH_TEGRA_194_SOC)
+extern const struct tegra_xusb_padctl_soc tegra194_xusb_padctl_soc;
+#endif
 
 #endif /* __PHY_TEGRA_XUSB_H */
-- 
2.17.1




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux