Re: [PATCH V3 00/15] arm64: dts: imx8: architecture improvement and adding imx8qm support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 12/09/19, Dong Aisheng wrote:
> IMX SCU based platforms (e.g. MX8QM/MX8QXP) are comprised of a number of SS
> (Subsystems), those SS may be shared between different SoCs while most of them
> can be reused like Devices Resources, Clocks, Power domains and etc.
> 
> This patch series aims to improve the MX8 architecture to comply with the HW
> design to save a lot of duplicated codes and benefits us a better
> maintainability and scalability in the future.
> 
> This patch series depends on another clk new binding series:
> https://patchwork.kernel.org/cover/11046287/

Thx for your update of this patch series. I'am running into the issue
that my linux next-20190904 unfortunately is not booting with it on my
imx8QM board. Kernel is just stuck during boot see below.

I applied your v5 of your clock binding patches series and applied this
series in v3. Your former two patch series worked well with next-20190716.

The last messages from the kernel are:

[    1.019208] imx-scu scu: mbox_request_channel_byname() could not locate channel named "gip3"
[    1.027316] imx-scu scu: failed to request mbox chan gip3, ret -22
[    1.033480] imx-scu scu: failed to enable general irq channel: -22
[    1.039646] imx-scu scu: NXP i.MX SCU Initialized
[    1.047414] a35_clk: failed to get clock rate -22
[    1.058682]  lcd0-pwm0: failed to power up resource 188 ret -22
[    1.064314] imx-scu-clk: probe of pwm_clk failed with error -22
[    1.070538]  lcd0: failed to power up resource 187 ret -22
[    1.075690] imx-scu-clk: probe of lcd_clk failed with error -22
[    1.085965] mipi_csi0_core_clk: failed to attached the power domain -2
[    1.092359] mipi_csi0_esc_clk: failed to attached the power domain -2
[    1.098777] mipi_csi0_i2c0_clk: failed to attached the power domain -2
[    1.105278] mipi_csi0_pwm0_clk: failed to attached the power domain -2
[    1.115744] imx8qm-pinctrl scu:pinctrl: initialized IMX pinctrl driver
[    1.123923] gpio-mxc 5d080000.gpio: IRQ index 1 not found
[    1.130276] gpio-mxc 5d090000.gpio: IRQ index 1 not found

I see similar messages also with your older working patches, only the
last two lines are new errors.

Best regards,

Oliver




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux