Add the device-tree binding documentation for Milbeaut SDHCI driver.
Signed-off-by: Takao Orito <orito.takao@xxxxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
.../devicetree/bindings/mmc/sdhci-milbeaut.txt | 30 ++++++++++++++++++++++
1 file changed, 30 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt b/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
new file mode 100644
index 0000000..627ee89
--- /dev/null
+++ b/Documentation/devicetree/bindings/mmc/sdhci-milbeaut.txt
@@ -0,0 +1,30 @@
+* SOCIONEXT Milbeaut SDHCI controller
+
+This file documents differences between the core properties in mmc.txt
+and the properties used by the sdhci_milbeaut driver.
+
+Required properties:
+- compatible: "socionext,milbeaut-m10v-sdhci-3.0"
+- clocks: Must contain an entry for each entry in clock-names. It is a
+ list of phandles and clock-specifier pairs.
+ See ../clocks/clock-bindings.txt for details.
+- clock-names: Should contain the following two entries:
+ "iface" - clock used for sdhci interface
+ "core" - core clock for sdhci controller
+
+Optional properties:
+- fujitsu,cmd-dat-delay-select: boolean property indicating that this host
+ requires the CMD_DAT_DELAY control to be enabled.
+
+Example:
+ sdhci3: mmc@1b010000 {
+ compatible = "socionext,milbeaut-m10v-sdhci-3.0";
+ reg = <0x1b010000 0x10000>;
+ interrupts = <0 265 0x4>;
+ voltage-ranges = <3300 3300>;
+ bus-width = <4>;
+ clocks = <&clk 7>, <&ahb_clk>;
+ clock-names = "core", "iface";
+ cap-sdio-irq;
+ fujitsu,cmd-dat-delay-select;
+ };
--
1.9.1
