Hello, This patchset adds support for IMX290 CMOS image sensor from Sony. Sensor can be programmed through I2C and 4-wire interface but the current driver only supports I2C interface. Also, the sensor is capable of outputting frames in following 3 interfaces: * CMOS logic parallel SDR output * Low voltage LVDS serial DDR output * CSI-2 serial data output But the current driver only supports CSI-2 output available from 4 lanes. In the case of sensor resolution, driver only supports 1920x1080 and 1280x720 at mid data rate of 445.5 Mpbs. The driver has been validated using Framos IMX290 module interfaced to 96Boards Dragonboard410c. Thanks, Mani Changes in v3: As per the review by Sakari: * Switched to pm runtime * Used link-frequency property * Removed useless read calls from buffered read function * Some other misc changes to the driver and binding Changes in v2: * Added Reviewed-by tag from Rob for bindings patch Manivannan Sadhasivam (3): dt-bindings: media: i2c: Add IMX290 CMOS sensor binding media: i2c: Add IMX290 CMOS image sensor driver MAINTAINERS: Add entry for IMX290 CMOS image sensor driver .../devicetree/bindings/media/i2c/imx290.txt | 57 ++ MAINTAINERS | 8 + drivers/media/i2c/Kconfig | 11 + drivers/media/i2c/Makefile | 1 + drivers/media/i2c/imx290.c | 881 ++++++++++++++++++ 5 files changed, 958 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/i2c/imx290.txt create mode 100644 drivers/media/i2c/imx290.c -- 2.17.1
