[PATCH v5 03/13] ARM: dts: imx7-colibri: Add touch controllers

[Philippe Schenker <philippe.schenker@xxxxxxxxxxx>]

Add touch controller that is connected over an I2C bus.
It is disabled by default because the pins are also used for PWM,
which is the standard use for colibri boards.

Signed-off-by: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>
Acked-by: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx>
Reviewed-by: Oleksandr Suvorov <oleksandr.suvorov@xxxxxxxxxxx>

---

Changes in v5:
- Add note in commit message about disabled status
- Added Olek's reviewed-by

Changes in v4:
- Add Marcel Ziswiler's Ack

Changes in v3:
- Fix commit message

Changes in v2:
- Deleted touchrevolution downstream stuff
- Use generic node name
- Better comment

 arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi | 24 +++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi b/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
index 45c4e721115a..6aa123cbdadb 100644
--- a/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
+++ b/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
@@ -145,6 +145,21 @@
 &i2c4 {
 	status = "okay";
 
+	/*
+	 * Touchscreen is using SODIMM 28/30, also used for PWM<B>, PWM<C>,
+	 * aka pwm2, pwm3. so if you enable touchscreen, disable the pwms
+	 */
+	touchscreen@4a {
+		compatible = "atmel,maxtouch";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_gpiotouch>;
+		reg = <0x4a>;
+		interrupt-parent = <&gpio1>;
+		interrupts = <9 IRQ_TYPE_EDGE_FALLING>;		/* SODIMM 28 */
+		reset-gpios = <&gpio1 10 GPIO_ACTIVE_HIGH>;	/* SODIMM 30 */
+		status = "disabled";
+	};
+
 	/* M41T0M6 real time clock on carrier board */
 	rtc: m41t0m6@68 {
 		compatible = "st,m41t0";
@@ -200,3 +215,12 @@
 	vmmc-supply = <&reg_3v3>;
 	status = "okay";
 };
+
+&iomuxc {
+	pinctrl_gpiotouch: touchgpios {
+		fsl,pins = <
+			MX7D_PAD_GPIO1_IO09__GPIO1_IO9		0x74
+			MX7D_PAD_GPIO1_IO10__GPIO1_IO10		0x14
+		>;
+	};
+};
-- 
2.23.0