Add id-gpios, vbus-gpios, vbus-supply and pinctrl properties for
usb-b-connector
Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
v6~v9 no changes
v5 changes:
1. add reviewed by Rob
v4 no changes
v3 changes:
1. add GPIO direction, and use fixed-regulator for GPIO controlled
VBUS regulator suggested by Rob;
v2 changes:
1. describe more clear for vbus-gpios and vbus-supply suggested by Hans
---
.../bindings/connector/usb-connector.txt | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/Documentation/devicetree/bindings/connector/usb-connector.txt b/Documentation/devicetree/bindings/connector/usb-connector.txt
index cef556d4e5ee..d357987181ee 100644
--- a/Documentation/devicetree/bindings/connector/usb-connector.txt
+++ b/Documentation/devicetree/bindings/connector/usb-connector.txt
@@ -17,6 +17,20 @@ Optional properties:
- self-powered: Set this property if the usb device that has its own power
source.
+Optional properties for usb-b-connector:
+- id-gpios: an input gpio for USB ID pin.
+- vbus-gpios: an input gpio for USB VBUS pin, used to detect presence of
+ VBUS 5V.
+ see gpio/gpio.txt.
+- vbus-supply: a phandle to the regulator for USB VBUS if needed when host
+ mode or dual role mode is supported.
+ Particularly, if use an output GPIO to control a VBUS regulator, should
+ model it as a regulator.
+ see regulator/fixed-regulator.yaml
+- pinctrl-names : a pinctrl state named "default" is optional
+- pinctrl-0 : pin control group
+ see pinctrl/pinctrl-bindings.txt
+
Optional properties for usb-c-connector:
- power-role: should be one of "source", "sink" or "dual"(DRP) if typec
connector has power support.
--
2.22.0
