On 8/9/19 11:00 AM, Dmitry Osipenko wrote:
09.08.2019 19:39, Sowjanya Komatineni пишет:
On 8/9/19 5:23 AM, Dmitry Osipenko wrote:
09.08.2019 2:46, Sowjanya Komatineni пишет:
This patch implements DFLL suspend and resume operation.
During system suspend entry, CPU clock will switch CPU to safe
clock source of PLLP and disables DFLL clock output.
DFLL driver suspend confirms DFLL disable state and errors out on
being active.
DFLL is re-initialized during the DFLL driver resume as it goes
through complete reset during suspend entry.
Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
drivers/clk/tegra/clk-dfll.c | 56 ++++++++++++++++++++++++++++++
drivers/clk/tegra/clk-dfll.h | 2 ++
drivers/clk/tegra/clk-tegra124-dfll-fcpu.c | 1 +
3 files changed, 59 insertions(+)
diff --git a/drivers/clk/tegra/clk-dfll.c b/drivers/clk/tegra/clk-dfll.c
index f8688c2ddf1a..eb298a5d7be9 100644
--- a/drivers/clk/tegra/clk-dfll.c
+++ b/drivers/clk/tegra/clk-dfll.c
@@ -1487,6 +1487,7 @@ static int dfll_init(struct tegra_dfll *td)
td->last_unrounded_rate = 0;
pm_runtime_enable(td->dev);
+ pm_runtime_irq_safe(td->dev);
pm_runtime_get_sync(td->dev);
dfll_set_mode(td, DFLL_DISABLED);
@@ -1513,6 +1514,61 @@ static int dfll_init(struct tegra_dfll *td)
return ret;
}
+/**
+ * tegra_dfll_suspend - check DFLL is disabled
+ * @dev: DFLL device *
+ *
+ * DFLL clock should be disabled by the CPUFreq driver. So, make
+ * sure it is disabled and disable all clocks needed by the DFLL.
+ */
+int tegra_dfll_suspend(struct device *dev)
+{
+ struct tegra_dfll *td = dev_get_drvdata(dev);
+
+ if (dfll_is_running(td)) {
+ dev_err(td->dev, "dfll is enabled while shouldn't be\n");
+ return -EBUSY;
+ }
+
+ reset_control_assert(td->dvco_rst);
+
+ return 0;
+}
+EXPORT_SYMBOL(tegra_dfll_suspend);
+
+/**
+ * tegra_dfll_resume - reinitialize DFLL on resume
+ * @dev: DFLL instance
+ *
+ * DFLL is disabled and reset during suspend and resume.
+ * So, reinitialize the DFLL IP block back for use.
+ * DFLL clock is enabled later in closed loop mode by CPUFreq
+ * driver before switching its clock source to DFLL output.
+ */
+int tegra_dfll_resume(struct device *dev)
+{
+ struct tegra_dfll *td = dev_get_drvdata(dev);
+
+ reset_control_deassert(td->dvco_rst);
This doesn't look right because I assume that DFLL resetting is
synchronous and thus clk should be enabled in order for reset to
propagate inside hardware.
+ pm_runtime_get_sync(td->dev);
Hence it will be better to remove the above reset_control_deassert() and
add here:
reset_control_reset(td->dvco_rst);
By the time dfll resume happens, dfll controller clock will already be enabled.
so doing reset de-assert before pm_runtime seems ok.
I don't see what enables the DFLL clock because it should be enabled by the CPUFreq driver
on resume from suspend and resume happens after resuming of the DFLL driver.
dvco_rst is part of peripheral clocks and all peripheral clocks are
restored by clk-tegra210 driver which happens before dfll driver resume.
So dfll rst thru part of peripheral clock enable is set prior to dfll
reset deassertion
