On 09/08/19 1:59 PM, Lokesh Vutla wrote:
From: Nikhil Devshatwar <nikhil.nd@xxxxxx>
Common processor board for K3 J721E platform has two push buttons
namely SW10 and SW11.
Add a gpio-keys device node to model them as input keys in Linux.
Add required pinmux nodes to set GPIO pins as input.
Reviewed-by: Keerthy <j-keerthy@xxxxxx>
Signed-off-by: Nikhil Devshatwar <nikhil.nd@xxxxxx>
Signed-off-by: Lokesh Vutla <lokeshvutla@xxxxxx>
---
.../dts/ti/k3-j721e-common-proc-board.dts | 37 +++++++++++++++++++
1 file changed, 37 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
index 509579ca3db2..d2894d55fbbe 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
@@ -6,12 +6,49 @@
/dts-v1/;
#include "k3-j721e-som-p0.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
/ {
chosen {
stdout-path = "serial2:115200n8";
bootargs = "console=ttyS2,115200n8 earlycon=ns16550a,mmio32,0x02800000";
};
+
+ gpio_keys: gpio-keys {
+ compatible = "gpio-keys";
+ autorepeat;
+ pinctrl-names = "default";
+ pinctrl-0 = <&sw10_button_pins_default &sw11_button_pins_default>;
+
+ sw10: sw10 {
+ label = "GPIO Key USER1";
+ linux,code = <BTN_0>;
+ gpios = <&main_gpio0 0 GPIO_ACTIVE_LOW>;
+ };
+
+ sw11: sw11 {
+ label = "GPIO Key USER2";
+ linux,code = <BTN_1>;
+ gpios = <&wkup_gpio0 7 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&main_pmx0 {
+ sw10_button_pins_default: sw10_button_pins_default {
+ pinctrl-single,pins = <
+ J721E_IOPAD(0x0, PIN_INPUT, 7) /* (AC18) EXTINTn.GPIO0_0 */
+ >;
+ };
+};
+
+&wkup_pmx0 {
+ sw11_button_pins_default: sw11_button_pins_default {
+ pinctrl-single,pins = <
+ J721E_WKUP_IOPAD(0xcc, PIN_INPUT, 7) /* (G28) WKUP_GPIO0_7 */
+ >;
+ };
};
&wkup_uart0 {
