Re: [PATCH v8 19/21] soc/tegra: pmc: Configure deep sleep control settings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



09.08.2019 2:46, Sowjanya Komatineni пишет:
> Tegra210 and prior Tegra chips have deep sleep entry and wakeup related
> timings which are platform specific that should be configured before
> entering into deep sleep.
> 
> Below are the timing specific configurations for deep sleep entry and
> wakeup.
> - Core rail power-on stabilization timer
> - OSC clock stabilization timer after SOC rail power is stabilized.
> - Core power off time is the minimum wake delay to keep the system
>   in deep sleep state irrespective of any quick wake event.
> 
> These values depends on the discharge time of regulators and turn OFF
> time of the PMIC to allow the complete system to finish entering into
> deep sleep state.
> 
> These values vary based on the platform design and are specified
> through the device tree.
> 
> This patch has implementation to configure these timings which are must
> to have for proper deep sleep and wakeup operations.
> 
> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
> ---
>  drivers/soc/tegra/pmc.c | 13 ++++++++++++-
>  1 file changed, 12 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/soc/tegra/pmc.c b/drivers/soc/tegra/pmc.c
> index e013ada7e4e9..9a78d8417367 100644
> --- a/drivers/soc/tegra/pmc.c
> +++ b/drivers/soc/tegra/pmc.c
> @@ -88,6 +88,8 @@
>  
>  #define PMC_CPUPWRGOOD_TIMER		0xc8
>  #define PMC_CPUPWROFF_TIMER		0xcc
> +#define PMC_COREPWRGOOD_TIMER		0x3c
> +#define PMC_COREPWROFF_TIMER		0xe0
>  
>  #define PMC_PWR_DET_VALUE		0xe4
>  
> @@ -2277,7 +2279,7 @@ static const struct tegra_pmc_regs tegra20_pmc_regs = {
>  
>  static void tegra20_pmc_init(struct tegra_pmc *pmc)
>  {
> -	u32 value;
> +	u32 value, osc, pmu, off;
>  
>  	/* Always enable CPU power request */
>  	value = tegra_pmc_readl(pmc, PMC_CNTRL);
> @@ -2303,6 +2305,15 @@ static void tegra20_pmc_init(struct tegra_pmc *pmc)
>  	value = tegra_pmc_readl(pmc, PMC_CNTRL);
>  	value |= PMC_CNTRL_SYSCLK_OE;
>  	tegra_pmc_writel(pmc, value, PMC_CNTRL);
> +
> +	osc = DIV_ROUND_UP(pmc->core_osc_time * 8192, 1000000);
> +	pmu = DIV_ROUND_UP(pmc->core_pmu_time * 32768, 1000000);
> +	off = DIV_ROUND_UP(pmc->core_off_time * 32768, 1000000);
> +	if (osc && pmu)
> +		tegra_pmc_writel(pmc, ((osc << 8) & 0xff00) | (pmu & 0xff),
> +				 PMC_COREPWRGOOD_TIMER);
> +	if (off)
> +		tegra_pmc_writel(pmc, off, PMC_COREPWROFF_TIMER);

The osc/pmu/off values are undefined if they are not defined in device-tree. I suppose this
need to be corrected in tegra_pmc_parse_dt() if the values really matter even if LP0 suspend
isn't supported in device-tree.

And I'm also not sure what's wrong with setting 0 for the timers.

>  }
>  
>  static void tegra20_pmc_setup_irq_polarity(struct tegra_pmc *pmc,
> 




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux