Documentation for AD7606B Analog to Digital Converter and software mode was added. Signed-off-by: Beniamin Bia <beniamin.bia@xxxxxxxxxx> --- Changes in v2: -nothing changed Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml index 509dbe9c84d2..2afe31747a70 100644 --- a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml +++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml @@ -13,6 +13,7 @@ maintainers: description: | Analog Devices AD7606 Simultaneous Sampling ADC https://www.analog.com/media/en/technical-documentation/data-sheets/ad7606_7606-6_7606-4.pdf + https://www.analog.com/media/en/technical-documentation/data-sheets/AD7606B.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/AD7616.pdf properties: @@ -22,6 +23,7 @@ properties: - adi,ad7606-8 - adi,ad7606-6 - adi,ad7606-4 + - adi,ad7606b - adi,ad7616 reg: @@ -87,7 +89,7 @@ properties: adi,sw-mode: description: - Software mode of operation, so far available only for ad7616. + Software mode of operation, so far available only for ad7616 and ad7606B. It is enabled when all three oversampling mode pins are connected to high level. The device is configured by the corresponding registers. If the adi,oversampling-ratio-gpios property is defined, then the driver will set the -- 2.17.1
