Re: [PATCH v3 07/21] ARM: dts: imx7-colibri: fix 1.8V/UHS support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Philippe,

On Wed, Aug 7, 2019 at 5:26 AM Philippe Schenker
<philippe.schenker@xxxxxxxxxxx> wrote:
>
> From: Stefan Agner <stefan.agner@xxxxxxxxxxx>
>
> Add pinmuxing and do not specify voltage restrictions for the usdhc
> instance available on the modules edge connector. This allows to use
> SD-cards with higher transfer modes if supported by the carrier board.
>
> Signed-off-by: Stefan Agner <stefan.agner@xxxxxxxxxxx>
> Signed-off-by: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>
>
> ---
>
> Changes in v3:
> - Add new commit message from Stefan's proposal on ML

The commit message has been improved, but there is also another point
I mentioned earlier:

>
> Changes in v2: None
>
>  arch/arm/boot/dts/imx7-colibri.dtsi | 23 ++++++++++++++++++++++-
>  1 file changed, 22 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/imx7-colibri.dtsi b/arch/arm/boot/dts/imx7-colibri.dtsi
> index 16d1a1ed1aff..67f5e0c87fdc 100644
> --- a/arch/arm/boot/dts/imx7-colibri.dtsi
> +++ b/arch/arm/boot/dts/imx7-colibri.dtsi
> @@ -326,7 +326,6 @@
>  &usdhc1 {
>         pinctrl-names = "default";
>         pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_cd_usdhc1>;
> -       no-1-8-v;
>         cd-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
>         disable-wp;
>         vqmmc-supply = <&reg_LDO2>;
> @@ -671,6 +670,28 @@
>                 >;
>         };
>
> +       pinctrl_usdhc1_100mhz: usdhc1grp_100mhz {

This new entry has been added and it is not referenced.

> +               fsl,pins = <
> +                       MX7D_PAD_SD1_CMD__SD1_CMD       0x5a
> +                       MX7D_PAD_SD1_CLK__SD1_CLK       0x1a
> +                       MX7D_PAD_SD1_DATA0__SD1_DATA0   0x5a
> +                       MX7D_PAD_SD1_DATA1__SD1_DATA1   0x5a
> +                       MX7D_PAD_SD1_DATA2__SD1_DATA2   0x5a
> +                       MX7D_PAD_SD1_DATA3__SD1_DATA3   0x5a
> +               >;
> +       };
> +
> +       pinctrl_usdhc1_200mhz: usdhc1grp_200mhz {

Same here.



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux