On 31. 07. 19 8:43, Philippe Schenker wrote:
On Tue, 2019-07-30 at 17:46 -0300, Fabio Estevam wrote:
On Tue, Jul 30, 2019 at 11:57 AM Philippe Schenker <dev@xxxxxxxxxxxx> wrote:
+ /* Atmel maxtouch controller */
+ atmel_mxt_ts: atmel_mxt_ts@4a {
Generic node names, please:
touchscreen@4a
+ compatible = "atmel,maxtouch";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_pcap_1>;
+ reg = <0x4a>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <9 IRQ_TYPE_EDGE_FALLING>; /* SODIMM 28 */
+ reset-gpios = <&gpio2 10 GPIO_ACTIVE_HIGH>; /* SODIMM 30 */
+ status = "disabled";
+ };
+
+ /*
+ * the PCAPs use SODIMM 28/30, also used for PWM<B>, PWM<C>, aka
pwm1,
+ * pwm4. So if you enable one of the PCAP controllers disable the
pwms.
+ */
+ pcap: pcap@10 {
touchscreen@10
+ /* TouchRevolution Fusion 7 and 10 multi-touch controller */
+ compatible = "touchrevolution,fusion-f0710a";
I do not find this binding documented.
Thanks for your feedback Fabio, and sorry such obvious stuff went through. I
will go through my whole patchset again more carefully lookup all the bindings.
Hi Philippe,
also look at the I2C sub-nodes - they should be sorted by the bus address.
In most of the patches it is not correct.
Michal
