Quoting Florian Fainelli <f.fainelli@xxxxxxxxx>:
On 7/24/2019 9:25 PM, René van Dorst wrote:
Adding support for port 5.
Port 5 can muxed/interface to:
- internal 5th GMAC of the switch; can be used as 2nd CPU port or as
extra port with an external phy for a 6th ethernet port.
- internal PHY of port 0 or 4; Used in most applications so that port 0
or 4 is the WAN port and interfaces with the 2nd GMAC of the SOC.
Signed-off-by: René van Dorst <opensource@xxxxxxxxxx>
[snip]
+ /* Setup port 5 */
+ priv->p5_intf_sel = P5_DISABLED;
+ interface = PHY_INTERFACE_MODE_NA;
+
+ if (!dsa_is_unused_port(ds, 5)) {
+ priv->p5_intf_sel = P5_INTF_SEL_GMAC5;
+ interface = of_get_phy_mode(ds->ports[5].dn);
+ } else {
+ /* Scan the ethernet nodes. Look for GMAC1, Lookup used phy */
+ for_each_child_of_node(dn, mac_np) {
+ if (!of_device_is_compatible(mac_np,
+ "mediatek,eth-mac"))
+ continue;
+ _id = of_get_property(mac_np, "reg", NULL);
+ if (be32_to_cpup(_id) != 1)
+ continue;
+
+ interface = of_get_phy_mode(mac_np);
+ phy_node = of_parse_phandle(mac_np, "phy-handle", 0);
+
+ if (phy_node->parent == priv->dev->of_node->parent) {
+ _id = of_get_property(phy_node, "reg", NULL);
+ id = be32_to_cpup(_id);
+ if (id == 0)
+ priv->p5_intf_sel = P5_INTF_SEL_PHY_P0;
+ if (id == 4)
+ priv->p5_intf_sel = P5_INTF_SEL_PHY_P4;
Hi Florian,
Can you use of_mdio_parse_addr() here?
Yes that function be used.
Thanks for mention this function.
I see that I can refactor this scan routine a bit more.
Also I missing a of_node_put(phy_node) at the end.
--
Florian
Greats,
René
