Hi Olivier
On 7/5/19 1:53 PM, Olivier Moysan wrote:
Add support of Cirrus cs42l51 audio codec on stm32mp157a-dk1 board.
Configuration overview:
- SAI2A is the CPU interface used for the codec audio playback
- SAI2B is the CPU interface used for the codec audio record
- SAI2A is configured as a clock provider for the audio codec
- SAI2A&B are configured as slave of the audio codec
- SAI2A&B share the same interface of the audio codec
Note:
In master mode, cs42l51 audio codec provides a bitclock
at 64 x FS, regardless of data width. This means that
slot width is always 32 bits.
Set slot width to 32 bits and slot number to 2
in SAI2A&B endpoint nodes, to match this constraint.
dai-tdm-slot-num and dai-tdm-slot-width properties are used here,
assuming that i2s is a special case of tdm, where slot number is 2.
Signed-off-by: Olivier Moysan <olivier.moysan@xxxxxx>
---
arch/arm/boot/dts/stm32mp157a-dk1.dts | 89 +++++++++++++++++++++++++++++++++++
1 file changed, 89 insertions(+)
...
+&sai2 {
+ clocks = <&rcc SAI2>, <&rcc PLL3_Q>, <&rcc PLL3_R>;
+ clock-names = "pclk", "x8k", "x11k";
+ pinctrl-names = "default", "sleep";
+ pinctrl-0 = <&sai2a_pins_a>, <&sai2b_pins_b>;
+ pinctrl-1 = <&sai2a_sleep_pins_a>, <&sai2b_sleep_pins_b>;
+ status = "okay";
+
+ sai2a: audio-controller@4400b004 {
+ #clock-cells = <0>;
+ dma-names = "tx";
+ clocks = <&rcc SAI2_K>;
+ clock-names = "sai_ck";
+ status = "okay";
+
+ sai2a_port: port {
+ sai2a_endpoint: endpoint {
+ remote-endpoint = <&cs42l51_tx_endpoint>;
+ format = "i2s";
+ mclk-fs = <256>;
+ dai-tdm-slot-num = <2>;
+ dai-tdm-slot-width = <32>;
+ };
+ };
+ };
+
You could use label to overload sai2a and sai2b. no ?
+ sai2b: audio-controller@4400b024 {
+ dma-names = "rx";
+ st,sync = <&sai2a 2>;
+ clocks = <&rcc SAI2_K>, <&sai2a>;
+ clock-names = "sai_ck", "MCLK";
+ status = "okay";
+
+ sai2b_port: port {
+ sai2b_endpoint: endpoint {
+ remote-endpoint = <&cs42l51_rx_endpoint>;
+ format = "i2s";
+ mclk-fs = <256>;
+ dai-tdm-slot-num = <2>;
+ dai-tdm-slot-width = <32>;
+ };
+ };
+ };
+};
+
&sdmmc1 {
pinctrl-names = "default", "opendrain", "sleep";
pinctrl-0 = <&sdmmc1_b4_pins_a>;
