On 15:20-20190722, Suman Anna wrote:
> Add the sub-mailbox nodes that are used to communicate between
> MPU and the two R5F remote processors present in the MCU domain.
> The parent mailbox cluster nodes are enabled and the interrupts
> associated with the Mailbox Cluster User interrupt used by the
> sub-mailbox nodes are also added. The GIC_SPI interrupt to be
> used is dynamically allocated and managed by the System Firmware
> through the ti-sci-intr irqchip driver.
>
> The sub-mailbox nodes utilize the System Mailbox clusters 1 and 2.
> These sub-mailbox nodes are added to match the hard-coded mailbox
> configuration used within the TI RTOS IPC software packages. The
> Cortex R5F processor sub-system is assumed to be running in Split
> mode, so a sub-mailbox node is used by each of the R5F cores. Only
> the sub-mailbox node from cluster 0 is used in case of Lockstep
> mode.
>
> Signed-off-by: Suman Anna <s-anna@xxxxxx>
> ---
> arch/arm64/boot/dts/ti/k3-am65-main.dtsi | 16 ++++++++++++++--
> 1 file changed, 14 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am65-main.dtsi b/arch/arm64/boot/dts/ti/k3-am65-main.dtsi
> index 0b3ea2a871ee..317563c995b1 100644
> --- a/arch/arm64/boot/dts/ti/k3-am65-main.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am65-main.dtsi
> @@ -426,7 +426,13 @@
> #mbox-cells = <1>;
> ti,mbox-num-users = <4>;
> ti,mbox-num-fifos = <16>;
> - status = "disabled";
> + interrupt-parent = <&intr_main_navss>;
> + interrupts = <164 0>;
> +
> + mbox_mcu_r5fss0_core0: mbox-mcu-r5fss0-core0 {
> + ti,mbox-tx = <1 0 0>;
> + ti,mbox-rx = <0 0 0>;
> + };
Should'nt this rather be a board specific node? This is completely
dependent on the pre-defined communication scheme with R5F firmware?
> };
>
> mailbox0_cluster1: mailbox@31f81000 {
> @@ -435,7 +441,13 @@
> #mbox-cells = <1>;
> ti,mbox-num-users = <4>;
> ti,mbox-num-fifos = <16>;
> - status = "disabled";
> + interrupt-parent = <&intr_main_navss>;
> + interrupts = <165 0>;
> +
> + mbox_mcu_r5fss0_core1: mbox-mcu-r5fss0-core1 {
> + ti,mbox-tx = <1 0 0>;
> + ti,mbox-rx = <0 0 0>;
> + };
> };
>
> mailbox0_cluster2: mailbox@31f82000 {
> --
> 2.22.0
>
--
Regards,
Nishanth Menon
