Re: [PATCH V6 16/21] soc/tegra: pmc: Add pmc wake support for tegra210

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



21.07.2019 22:40, Sowjanya Komatineni пишет:
> This patch implements PMC wakeup sequence for Tegra210 and defines
> common used RTC alarm wake event.
> 
> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
> ---
>  drivers/soc/tegra/pmc.c | 111 ++++++++++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 111 insertions(+)
> 
> diff --git a/drivers/soc/tegra/pmc.c b/drivers/soc/tegra/pmc.c
> index 91c84d0e66ae..c556f38874e1 100644
> --- a/drivers/soc/tegra/pmc.c
> +++ b/drivers/soc/tegra/pmc.c
> @@ -57,6 +57,12 @@
>  #define  PMC_CNTRL_SYSCLK_OE		BIT(11) /* system clock enable */
>  #define  PMC_CNTRL_SYSCLK_POLARITY	BIT(10) /* sys clk polarity */
>  #define  PMC_CNTRL_MAIN_RST		BIT(4)
> +#define  PMC_CNTRL_LATCH_WAKEUPS	BIT(5)
> +
> +#define PMC_WAKE_MASK			0x0c
> +#define PMC_WAKE_LEVEL			0x10
> +#define PMC_WAKE_STATUS			0x14
> +#define PMC_SW_WAKE_STATUS		0x18
>  
>  #define DPD_SAMPLE			0x020
>  #define  DPD_SAMPLE_ENABLE		BIT(0)
> @@ -87,6 +93,11 @@
>  
>  #define PMC_SCRATCH41			0x140
>  
> +#define PMC_WAKE2_MASK			0x160
> +#define PMC_WAKE2_LEVEL			0x164
> +#define PMC_WAKE2_STATUS		0x168
> +#define PMC_SW_WAKE2_STATUS		0x16c
> +
>  #define PMC_SENSOR_CTRL			0x1b0
>  #define  PMC_SENSOR_CTRL_SCRATCH_WRITE	BIT(2)
>  #define  PMC_SENSOR_CTRL_ENABLE_RST	BIT(1)
> @@ -1922,6 +1933,55 @@ static const struct irq_domain_ops tegra_pmc_irq_domain_ops = {
>  	.alloc = tegra_pmc_irq_alloc,
>  };
>  
> +static int tegra210_pmc_irq_set_wake(struct irq_data *data, unsigned int on)
> +{
> +	struct tegra_pmc *pmc = irq_data_get_irq_chip_data(data);
> +	unsigned int offset, bit;
> +	u32 value;
> +
> +	if (data->hwirq == ULONG_MAX)
> +		return 0;
> +
> +	offset = data->hwirq / 32;
> +	bit = data->hwirq % 32;
> +
> +	/*
> +	 * Latch wakeups to SW_WAKE_STATUS register to capture events
> +	 * that would not make it into wakeup event register during LP0 exit.
> +	 */
> +	value = tegra_pmc_readl(pmc, PMC_CNTRL);
> +	value |= PMC_CNTRL_LATCH_WAKEUPS;
> +	tegra_pmc_writel(pmc, value, PMC_CNTRL);
> +	udelay(120);

Why it takes so much time to latch the values? Shouldn't some status-bit
be polled for the completion of latching?

Is this register-write really getting buffered in the PMC?

> +	value &= ~PMC_CNTRL_LATCH_WAKEUPS;
> +	tegra_pmc_writel(pmc, value, PMC_CNTRL);
> +	udelay(120);

120 usecs to remove latching, really?

> +	tegra_pmc_writel(pmc, 0, PMC_SW_WAKE_STATUS);
> +	tegra_pmc_writel(pmc, 0, PMC_SW_WAKE2_STATUS);
> +
> +	tegra_pmc_writel(pmc, 0, PMC_WAKE_STATUS);
> +	tegra_pmc_writel(pmc, 0, PMC_WAKE2_STATUS);
> +
> +	/* enable PMC wake */
> +	if (data->hwirq >= 32)
> +		offset = PMC_WAKE2_MASK;
> +	else
> +		offset = PMC_WAKE_MASK;
> +
> +	value = tegra_pmc_readl(pmc, offset);
> +
> +	if (on)
> +		value |= 1 << bit;
> +	else
> +		value &= ~(1 << bit);
> +
> +	tegra_pmc_writel(pmc, value, offset);

Why the latching is done *before* writing into the WAKE registers? What
it is latching then?

> +	return 0;
> +}
> +
>  static int tegra186_pmc_irq_set_wake(struct irq_data *data, unsigned int on)
>  {
>  	struct tegra_pmc *pmc = irq_data_get_irq_chip_data(data);
> @@ -1954,6 +2014,49 @@ static int tegra186_pmc_irq_set_wake(struct irq_data *data, unsigned int on)
>  	return 0;
>  }
>  
> +static int tegra210_pmc_irq_set_type(struct irq_data *data, unsigned int type)
> +{
> +	struct tegra_pmc *pmc = irq_data_get_irq_chip_data(data);
> +	unsigned int offset, bit;
> +	u32 value;
> +
> +	if (data->hwirq == ULONG_MAX)
> +		return 0;
> +
> +	offset = data->hwirq / 32;
> +	bit = data->hwirq % 32;
> +
> +	if (data->hwirq >= 32)
> +		offset = PMC_WAKE2_LEVEL;
> +	else
> +		offset = PMC_WAKE_LEVEL;
> +
> +	value = tegra_pmc_readl(pmc, offset);
> +
> +	switch (type) {
> +	case IRQ_TYPE_EDGE_RISING:
> +	case IRQ_TYPE_LEVEL_HIGH:
> +		value |= 1 << bit;
> +		break;
> +
> +	case IRQ_TYPE_EDGE_FALLING:
> +	case IRQ_TYPE_LEVEL_LOW:
> +		value &= ~(1 << bit);
> +		break;
> +
> +	case IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING:
> +		value ^= 1 << bit;
> +		break;
> +
> +	default:
> +		return -EINVAL;
> +	}
> +
> +	tegra_pmc_writel(pmc, value, offset);

Shouldn't the WAKE_LEVEL be latched as well?

> +	return 0;
> +}
> +
>  static int tegra186_pmc_irq_set_type(struct irq_data *data, unsigned int type)
>  {
>  	struct tegra_pmc *pmc = irq_data_get_irq_chip_data(data);
> @@ -2540,6 +2643,10 @@ static const struct pinctrl_pin_desc tegra210_pin_descs[] = {
>  	TEGRA210_IO_PAD_TABLE(TEGRA_IO_PIN_DESC)
>  };
>  
> +static const struct tegra_wake_event tegra210_wake_events[] = {
> +	TEGRA_WAKE_IRQ("rtc", 16, 2),
> +};
> +
>  static const struct tegra_pmc_soc tegra210_pmc_soc = {
>  	.num_powergates = ARRAY_SIZE(tegra210_powergates),
>  	.powergates = tegra210_powergates,
> @@ -2557,10 +2664,14 @@ static const struct tegra_pmc_soc tegra210_pmc_soc = {
>  	.regs = &tegra20_pmc_regs,
>  	.init = tegra20_pmc_init,
>  	.setup_irq_polarity = tegra20_pmc_setup_irq_polarity,
> +	.irq_set_wake = tegra210_pmc_irq_set_wake,
> +	.irq_set_type = tegra210_pmc_irq_set_type,
>  	.reset_sources = tegra210_reset_sources,
>  	.num_reset_sources = ARRAY_SIZE(tegra210_reset_sources),
>  	.reset_levels = NULL,
>  	.num_reset_levels = 0,
> +	.num_wake_events = ARRAY_SIZE(tegra210_wake_events),
> +	.wake_events = tegra210_wake_events,
>  };
>  
>  #define TEGRA186_IO_PAD_TABLE(_pad)					     \
> 




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux