In general, group is the same as the port, but some
boards specify a special group for better load
balancing of each processing unit.
Signed-off-by: Jiangfeng Xiao <xiaojiangfeng@xxxxxxxxxx>
---
Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt b/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
index d1df8a0..464c0da 100644
--- a/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
+++ b/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
@@ -10,6 +10,7 @@ Required properties:
phandle, specifies a reference to the syscon ppe node
port, port number connected to the controller
channel, recv channel start from channel * number (RX_DESC_NUM)
+ group, field in the pkg desc, in general, it is the same as the port.
- phy-mode: see ethernet.txt [1].
Optional properties:
@@ -66,7 +67,7 @@ Example:
reg = <0x28b0000 0x10000>;
interrupts = <0 413 4>;
phy-mode = "mii";
- port-handle = <&ppe 31 0>;
+ port-handle = <&ppe 31 0 31>;
};
ge0: ethernet@2800000 {
@@ -74,7 +75,7 @@ Example:
reg = <0x2800000 0x10000>;
interrupts = <0 402 4>;
phy-mode = "sgmii";
- port-handle = <&ppe 0 1>;
+ port-handle = <&ppe 0 1 0>;
phy-handle = <&phy0>;
};
@@ -83,6 +84,6 @@ Example:
reg = <0x2880000 0x10000>;
interrupts = <0 410 4>;
phy-mode = "sgmii";
- port-handle = <&ppe 8 2>;
+ port-handle = <&ppe 8 2 8>;
phy-handle = <&phy1>;
};
--
1.8.5.6
