To support Rx in-band wakeup, one must create an interrupt specifier with
edge sensitivity on Rx pin and an addtional pinctrl to reconfigure Rx pin
to normal GPIO in sleep state. Driver will switch to sleep mode pinctrl and
enable irq wake before suspend and restore to default settings when
resuming.
Signed-off-by: Claire Chang <tientzu@xxxxxxxxxxxx>
---
changes in v2:
just document 'interrupts' instead of 'interrupts-extended'
.../devicetree/bindings/serial/mtk-uart.txt | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/serial/mtk-uart.txt b/Documentation/devicetree/bindings/serial/mtk-uart.txt
index bcfb13194f16..36b760c25ee3 100644
--- a/Documentation/devicetree/bindings/serial/mtk-uart.txt
+++ b/Documentation/devicetree/bindings/serial/mtk-uart.txt
@@ -21,7 +21,12 @@ Required properties:
- reg: The base address of the UART register bank.
-- interrupts: A single interrupt specifier.
+- interrupts:
+ index 0: an interrupt specifier for the UART controller itself
+ index 1: optional, an interrupt specifier with edge sensitivity on Rx pin to
+ support Rx in-band wake up. If one would like to use this feature,
+ one must create an addtional pinctrl to reconfigure Rx pin to normal
+ GPIO before suspend.
- clocks : Must contain an entry for each entry in clock-names.
See ../clocks/clock-bindings.txt for details.
@@ -37,7 +42,11 @@ Example:
uart0: serial@11006000 {
compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart";
reg = <0x11006000 0x400>;
- interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>;
+ interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>,
+ <GIC_SPI 52 IRQ_TYPE_EDGE_FALLING>;
clocks = <&uart_clk>, <&bus_clk>;
clock-names = "baud", "bus";
+ pinctrl-names = "default", "sleep";
+ pinctrl-0 = <&uart_pin>;
+ pinctrl-1 = <&uart_pin_sleep>;
};
--
2.22.0.410.gd8fdbe21b5-goog
