On 07-06-19, 09:56, Srinivas Kandagatla wrote: > This patch adds bindings for Qualcomm soundwire controller. > > Qualcomm SoundWire Master controller is present in most Qualcomm SoCs > either integrated as part of WCD audio codecs via slimbus or > as part of SOC I/O. > > Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx> > --- > .../bindings/soundwire/qcom,swr.txt | 62 +++++++++++++++++++ So I was expecting to see bus support patches for OF first. I think you have missed those changes. Please do include those in v2 with bindings and OF support for bus. > 1 file changed, 62 insertions(+) > create mode 100644 Documentation/devicetree/bindings/soundwire/qcom,swr.txt > > diff --git a/Documentation/devicetree/bindings/soundwire/qcom,swr.txt b/Documentation/devicetree/bindings/soundwire/qcom,swr.txt > new file mode 100644 > index 000000000000..eb84d0f4f36f > --- /dev/null > +++ b/Documentation/devicetree/bindings/soundwire/qcom,swr.txt > @@ -0,0 +1,62 @@ > +Qualcomm SoundWire Controller > + > +This binding describes the Qualcomm SoundWire Controller Bindings. > + > +Required properties: > + > +- compatible: Must be "qcom,soundwire-v<MAJOR>.<MINOR>.<STEP>", > + example: > + "qcom,soundwire-v1.3.0" > + "qcom,soundwire-v1.5.0" > + "qcom,soundwire-v1.6.0" > +- reg: SoundWire controller address space. > +- interrupts: SoundWire controller interrupt. > +- clock-names: Must contain "iface". > +- clocks: Interface clocks needed for controller. > +- #sound-dai-cells: Must be 1 for digital audio interfaces on the controllers. > +- #address-cells: Must be 1 for SoundWire devices; > +- #size-cells: Must be <0> as SoundWire addresses have no size component. > +- qcom,dout-ports: Must be count of data out ports > +- qcom,din-ports: Must be count of data in ports On these I think we should have specified dpn properties as specified in DisCo, but then looking at spec we do not define that for master, but bus seems to have it. Pierre do you why master does not have dpn properties in DisCo? > +- qcom,ports-offset1: Must be frame offset1 of each data port. > + Out followed by In. Used for Block size calculation. > +- qcom,ports-offset2: Must be frame offset2 of each data port. > + Out followed by In. Used for Block size calculation. > +- qcom,ports-sinterval-low: Must be sample interval low of each data port. > + Out followed by In. Used for Sample Interval calculation. These are software so do not belong here -- ~Vinod
