From: sudheer Kumar veliseti <sudheer.open@xxxxxxxxx>
Signed-off-by: sudheer veliseti <sudheer.open@xxxxxxxxx>
---
.../bindings/serial/ast2500-dma-uart.txt | 40 +++++++++++++++++++
1 file changed, 40 insertions(+)
create mode 100644 Documentation/devicetree/bindings/serial/ast2500-dma-uart.txt
diff --git a/Documentation/devicetree/bindings/serial/ast2500-dma-uart.txt b/Documentation/devicetree/bindings/serial/ast2500-dma-uart.txt
new file mode 100644
index 000000000000..ff9bb6146bd6
--- /dev/null
+++ b/Documentation/devicetree/bindings/serial/ast2500-dma-uart.txt
@@ -0,0 +1,40 @@
+
+node for DMA controller:
+ ast_uart_sdma: uart_sdma@1e79e000 {
+ compatible = "aspeed,ast-uart-sdma";
+ reg = <0x1e79e000 0x400>;
+ interrupts = <50>;
+ status = "disabled";
+ };
+this node doesn't binds with any driver.
+DMA controller is handled as a separate SW layer,and is included in the same driver.
+This DMA controller node is included in DT just for Register and interrupt details
+
+
+
+node for DMA-UART :
+
+
+Required properties:
+
+- compatible: "aspeed,ast-sdma-uart"
+- reg: The base address of the UART register bank
+- interrupts: should contain interrupt specifier.
+- clocks: Clock driving the hardware;
+- pinctrl-0 : list of pinconfigurations
+- dma-channel: channel of DMA-controller which is used
+
+Example:
+
+ dma_uart1: dma_uart1@1e783000{
+ compatible = "aspeed,ast-sdma-uart";
+ reg = <0x1e783000 0x1000>;
+ reg-shift = <2>;
+ interrupts = <9>;
+ clocks = <&syscon ASPEED_CLK_GATE_UART1CLK>;
+ dma-channel = <0>;
+ no-loopback-test;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_txd1_default &pinctrl_rxd1_default>;
+ status = "disabled";
+ };
--
2.17.1
