From: Sean Wang <sean.wang@xxxxxxxxxxxx> Not every platform has the pinctrl device integrates the GPIO the function such as MT7621 whose pinctrl and GPIO are separate hardware so adding an additional boot-gpios property for such platform allows them to bring up the device. Signed-off-by: Sean Wang <sean.wang@xxxxxxxxxxxx> --- .../devicetree/bindings/net/mediatek-bluetooth.txt | 13 +++++++++++++ 1 file changed, 13 insertions(+) diff --git a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt index 41a7dcc80f5b..14f23b354a6d 100644 --- a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt +++ b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt @@ -50,11 +50,24 @@ Required properties: "mediatek,mt7663u-bluetooth": for MT7663U device "mediatek,mt7668u-bluetooth": for MT7668U device - vcc-supply: Main voltage regulator + +If the pin controller on the platform can support both pinmux and GPIO +control such as the most of MediaTek platform. Please use below properties. + - pinctrl-names: Should be "default", "runtime" - pinctrl-0: Should contain UART RXD low when the device is powered up to enter proper bootstrap mode. - pinctrl-1: Should contain UART mode pin ctrl +Else, the pin controller on the platform only can support pinmux control and +the GPIO control still has to rely on the dedicated GPIO controller such as +a legacy MediaTek SoC, MT7621. Please use the below properties. + +- boot-gpios: GPIO same to the pin as UART RXD and used to keep LOW when + the device is powered up to enter proper bootstrap mode when +- pinctrl-names: Should be "default" +- pinctrl-0: Should contain UART mode pin ctrl + Optional properties: - reset-gpios: GPIO used to reset the device whose initial state keeps low, -- 2.17.1
