On Thu, May 23, 2019 at 8:30 PM Yuantian Tang <andy.tang@xxxxxxx> wrote: > > Add nxp sa56004 chip node for temperature monitor. > > Signed-off-by: Yuantian Tang <andy.tang@xxxxxxx> > --- > arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts | 5 +++++ > arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts | 5 +++++ > 2 files changed, 10 insertions(+) > > diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts > index b359068d9605..31fd626dd344 100644 > --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts > +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts > @@ -131,6 +131,11 @@ > compatible = "atmel,24c512"; > reg = <0x57>; > }; > + > + temp@4c { The recommended name for temperature senor in dts spec is temperature-sensor. > + compatible = "nxp,sa56004"; The binding says the following property is required. If it is not the case, probably we should update the binding. - vcc-supply: vcc regulator for the supply voltage. > + reg = <0x4c>; > + }; > }; > > i2c@5 { > diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts > index f9c272fb0738..012b3f8696b7 100644 > --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts > +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts > @@ -119,6 +119,11 @@ > compatible = "nxp,pcf2129"; > reg = <0x51>; > }; > + > + temp@4c { > + compatible = "nxp,sa56004"; > + reg = <0x4c>; > + }; > }; > }; > }; > -- > 2.17.1 >