On Wed, May 22, 2019 at 06:43:22PM +0000, Trent Piepho wrote:
> Generally, the output clock pin is only used for testing and only serves
> as a source of RF noise after this. It could be used to daisy-chain
> PHYs, but this is uncommon. Since the PHY can disable the output, make
> doing so an option. I do this by adding another enumeration to the
> allowed values of ti,clk-output-sel.
>
> The code was not using the value DP83867_CLK_O_SEL_REF_CLK as one might
> expect: to select the REF_CLK as the output. Rather it meant "keep
> clock output setting as is", which, depending on PHY strapping, might
> not be outputting REF_CLK.
>
> Change this so DP83867_CLK_O_SEL_REF_CLK means enable REF_CLK output.
> Omitting the property will leave the setting as is (which was the
> previous behavior in this case).
>
> Out of range values were silently converted into
> DP83867_CLK_O_SEL_REF_CLK. Change this so they generate an error.
>
> Cc: Andrew Lunn <andrew@xxxxxxx>
> Cc: Florian Fainelli <f.fainelli@xxxxxxxxx>
> Cc: Heiner Kallweit <hkallweit1@xxxxxxxxx>
> Signed-off-by: Trent Piepho <tpiepho@xxxxxxxxxx>
Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
Andrew
