Schrempf Frieder <frieder.schrempf@xxxxxxxxxx> wrote on Tue, 21 May 2019 09:31:04 +0000: > Hi Kamal, > > On 20.05.19 21:05, Kamal Dasu wrote: > > nand-ecc-strength and nand-ecc-step-size can be made optional as > > brcmnand driver can support using raw NAND layer detected values. > > > > Signed-off-by: Kamal Dasu <kdasu.kdev@xxxxxxxxx> > > --- > > Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++-- > > 1 file changed, 2 insertions(+), 2 deletions(-) > > > > diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt > > index bcda1df..29feaba 100644 > > --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt > > +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt > > @@ -101,10 +101,10 @@ Required properties: > > number (e.g., 0, 1, 2, etc.) > > - #address-cells : see partition.txt > > - #size-cells : see partition.txt > > -- nand-ecc-strength : see nand.txt > > -- nand-ecc-step-size : must be 512 or 1024. See nand.txt > > > > Optional properties: > > +- nand-ecc-strength : see nand.txt > > +- nand-ecc-step-size : must be 512 or 1024. See nand.txt > > - nand-on-flash-bbt : boolean, to enable the on-flash BBT for this > > chip-select. See nand.txt > > - brcm,nand-oob-sector-size : integer, to denote the spare area sector size > > I think you also need to change all references to nand.txt. This file > was recently moved to nand-controller.yaml. > Oops, completely forgot about that *again*. Thanks for pointing it Frieder! Miquèl
