Some SoCs with a dwc2 USB controller may need to keep the PHY on to support remote wakeup. Allow specifying this as a device tree property. Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx> --- For relevant prior discussion on this patch, see: https://lkml.kernel.org/r/1435017144-2971-3-git-send-email-dianders@xxxxxxxxxxxx I didn't make any changes from the prior version since I never found out what Rob thought of my previous arguments. If folks want a change, perhaps they could choose from these options: 1. Assume that all dwc2 hosts would like to keep their PHY on for suspend if there's a USB wakeup enabled, thus we totally drop this binding. This doesn't seem super great to me since I'd bet that many devices that use dwc2 weren't designed for USB wakeup (they may not keep enough clocks or rails on) so we might be wasting power for nothing. 2. Rename this property to "snps,wakeup-from-suspend-with-phy" to make it more obvious that this property is intended both to document that wakeup from suspend is possible and that we need the PHY for said wakeup. 3. Rename this property to "snps,can-wakeup-from-suspend" and assume it's implicit that if we can wakeup from suspend that we need to keep the PHY on. If/when someone shows that a device exists using dwc2 where we can wakeup from suspend without the PHY they can add a new property. NOTE FOR REPOST: - In v2 Rob said [1] he'd prefer something based on the SoC compatibility string, but that doesn't work because not all boards will have the regulator setup / board design / suspend logic necessary to make this work. [1] https://lkml.kernel.org/r/20190430012328.GA25660@bogus Changes in v3: None Changes in v2: None Documentation/devicetree/bindings/usb/dwc2.txt | 3 +++ 1 file changed, 3 insertions(+) diff --git a/Documentation/devicetree/bindings/usb/dwc2.txt b/Documentation/devicetree/bindings/usb/dwc2.txt index 49eac0dc86b0..aafff3a6904d 100644 --- a/Documentation/devicetree/bindings/usb/dwc2.txt +++ b/Documentation/devicetree/bindings/usb/dwc2.txt @@ -42,6 +42,8 @@ Refer to phy/phy-bindings.txt for generic phy consumer properties - g-rx-fifo-size: size of rx fifo size in gadget mode. - g-np-tx-fifo-size: size of non-periodic tx fifo size in gadget mode. - g-tx-fifo-size: size of periodic tx fifo per endpoint (except ep0) in gadget mode. +- snps,need-phy-for-wake: If present indicates that the phy needs to be left + on for remote wakeup during suspend. - snps,reset-phy-on-wake: If present indicates that we need to reset the PHY when we detect a wakeup. This is due to a hardware errata. @@ -58,4 +60,5 @@ Example: clock-names = "otg"; phys = <&usbphy>; phy-names = "usb2-phy"; + snps,need-phy-for-wake; }; -- 2.21.0.1020.gf2820cf01a-goog
