Add sdcard uhs modes up to DDR50 and push eMMC up to 200Mhz With the new tuning method, these modes appear to be stable Signed-off-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx> --- This particular board has always been painful when it comes to its eMMC modules. While testing the new tuning method introduced in the last cycle, I have not seen any issue with HS200@200Mhz. That being said, I only have the 16GB module. In the past, problems have been reported with other modules while it was fine on the one I have. Clearly, I don't have the full picture. Kevin, I don't know how you prefer to proceed. I am personally in no rush to see this applied. I'm sending this mainly to make sure it is shared and give people a chance to report issues. arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts index 1cc9dc68ef00..5a139e7b1c60 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts @@ -255,6 +255,10 @@ bus-width = <4>; cap-sd-highspeed; + sd-uhs-sdr12; + sd-uhs-sdr25; + sd-uhs-sdr50; + sd-uhs-ddr50; max-frequency = <100000000>; disable-wp; @@ -272,7 +276,7 @@ pinctrl-names = "default", "clk-gate"; bus-width = <8>; - max-frequency = <100000000>; + max-frequency = <200000000>; non-removable; disable-wp; cap-mmc-highspeed; -- 2.20.1
