On Wed, May 08, 2019 at 10:23:15PM +0530, Manivannan Sadhasivam wrote: > Hello, > > This patchset adds reset controller support for Bitmain BM1880 SoC. > BM1880 SoC has two reset controllers each controlling reset lines of > different peripherals. And the reset-simple driver has been reused here. > Sorry, above information was wrong! Actually there is only one reset controller in this SoC. The other one (clk_rst) is a set of registers used for clock gating functionality (clarified by Bitmain Engineer), so I will remove it in next version. Thanks, Mani > This patchset has been tested on 96Boards Sophon Edge board. > > Thanks, > Mani > > Changes in v2: > > As per review from Philipp: > > * Reused reset_simple_active_low struct instead of a new one for bm1880 > * Splitted the SPDX license change to a separate commit > * Added Reviewed-by tags from Rob and Philipp > > Manivannan Sadhasivam (4): > dt-bindings: reset: Add devicetree binding for BM1880 reset controller > arm64: dts: bitmain: Add reset controller support for BM1880 SoC > reset: Add reset controller support for BM1880 SoC > reset: Switch to SPDX license identifier for reset-simple > > .../bindings/reset/bitmain,bm1880-reset.txt | 18 +++ > arch/arm64/boot/dts/bitmain/bm1880.dtsi | 17 +++ > drivers/reset/Kconfig | 3 +- > drivers/reset/reset-simple.c | 8 +- > .../dt-bindings/reset/bitmain,bm1880-reset.h | 106 ++++++++++++++++++ > 5 files changed, 146 insertions(+), 6 deletions(-) > create mode 100644 Documentation/devicetree/bindings/reset/bitmain,bm1880-reset.txt > create mode 100644 include/dt-bindings/reset/bitmain,bm1880-reset.h > > -- > 2.17.1 >
