Re: [PATCH] ARM: dts: am57xx-idk: Remove support for voltage switching for SD card

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



* Faiz Abbas <faiz_abbas@xxxxxx> [190502 01:48]:
> If UHS speed modes are enabled, a compatible SD card switches down to
> 1.8V during enumeration. If after this a software reboot/crash takes
> place and on-chip ROM tries to enumerate the SD card, the difference in
> IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card.
> 
> The fix for this is to have support for power cycling the card in
> hardware (with a PORz/soft-reset line causing a power cycle of the
> card). Since am571x-, am572x- and am574x-idk don't have this
> capability, disable voltage switching for these boards.
> 
> The major effect of this is that the maximum supported speed
> mode is now high speed(50 MHz) down from SDR104(200 MHz).

This sounds a bit urgent, does it also need a stable tag or is
it safe to apply against any earlier kernels?

Regards,

Tony

> Signed-off-by: Faiz Abbas <faiz_abbas@xxxxxx>
> ---
>  arch/arm/boot/dts/am57xx-idk-common.dtsi | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/arch/arm/boot/dts/am57xx-idk-common.dtsi b/arch/arm/boot/dts/am57xx-idk-common.dtsi
> index f7bd26458915..42e433da79ec 100644
> --- a/arch/arm/boot/dts/am57xx-idk-common.dtsi
> +++ b/arch/arm/boot/dts/am57xx-idk-common.dtsi
> @@ -420,6 +420,7 @@
>  	vqmmc-supply = <&ldo1_reg>;
>  	bus-width = <4>;
>  	cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>; /* gpio 219 */
> +	no-1-8-v;
>  };
>  
>  &mmc2 {
> -- 
> 2.19.2
> 



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux