Document PCIe DPD pinctrl optional property to put PEX clk & BIAS pads in low power mode. Signed-off-by: Manikanta Maddireddy <mmaddireddy@xxxxxxxxxx> --- V2: Using standard pinctrl names, default and idle .../devicetree/bindings/pci/nvidia,tegra20-pcie.txt | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt index 145a4f04194f..7939bca47861 100644 --- a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt +++ b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt @@ -65,6 +65,14 @@ Required properties: - afi - pcie_x +Optional properties: +- pinctrl-names: A list of pinctrl state names. Must contain the following + entries: + - "default": active state, puts PCIe I/O out of deep power down state + - "idle": puts PCIe I/O into deep power down state +- pinctrl-0: phandle for the default/active state of pin configurations. +- pinctrl-1: phandle for the idle state of pin configurations. + Required properties on Tegra124 and later (deprecated): - phys: Must contain an entry for each entry in phy-names. - phy-names: Must include the following entries: -- 2.17.1
