Add DT binding documentation for the Linux driver for the SiFive
PRCI clock & reset control IP block, as found on the SiFive
FU540 chip.
This version includes changes requested by Stephen Boyd
<sboyd@xxxxxxxxxx> and Rob Herring <robh@xxxxxxxxxx>, and
fixes some errors in the initial version.
Signed-off-by: Paul Walmsley <paul.walmsley@xxxxxxxxxx>
Signed-off-by: Paul Walmsley <paul@xxxxxxxxx>
Cc: Michael Turquette <mturquette@xxxxxxxxxxxx>
Cc: Stephen Boyd <sboyd@xxxxxxxxxx>
Cc: Rob Herring <robh+dt@xxxxxxxxxx>
Cc: Mark Rutland <mark.rutland@xxxxxxx>
Cc: Palmer Dabbelt <palmer@xxxxxxxxxx>
Cc: Megan Wachs <megan@xxxxxxxxxx>
Cc: linux-clk@xxxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: linux-riscv@xxxxxxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
---
.../bindings/clock/sifive/fu540-prci.txt | 46 +++++++++++++++++++
1 file changed, 46 insertions(+)
create mode 100644 Documentation/devicetree/bindings/clock/sifive/fu540-prci.txt
diff --git a/Documentation/devicetree/bindings/clock/sifive/fu540-prci.txt b/Documentation/devicetree/bindings/clock/sifive/fu540-prci.txt
new file mode 100644
index 000000000000..349808f4fb8c
--- /dev/null
+++ b/Documentation/devicetree/bindings/clock/sifive/fu540-prci.txt
@@ -0,0 +1,46 @@
+SiFive FU540 PRCI bindings
+
+On the FU540 family of SoCs, most system-wide clock and reset integration
+is via the PRCI IP block.
+
+Required properties:
+- compatible: Should be "sifive,<chip>-prci". Only one value is
+ supported: "sifive,fu540-c000-prci"
+- reg: Should describe the PRCI's register target physical address region
+- clocks: Should point to the hfclk device tree node and the rtcclk
+ device tree node. The RTC clock here is not a time-of-day clock,
+ but is instead a high-stability clock source for system timers
+ and cycle counters.
+- #clock-cells: Should be <1>
+
+The clock consumer should specify the desired clock via the clock ID
+macros defined in include/dt-bindings/clock/sifive-fu540-prci.h.
+These macros begin with PRCI_CLK_.
+
+The hfclk and rtcclk nodes are required, and represent physical
+crystals or resonators located on the PCB. These nodes should be present
+underneath /, rather than /soc.
+
+Examples:
+
+/* under /, in PCB-specific DT data */
+hfclk: hfclk {
+ #clock-cells = <0>;
+ compatible = "fixed-clock";
+ clock-frequency = <33333333>;
+ clock-output-names = "hfclk";
+};
+rtcclk: rtcclk {
+ #clock-cells = <0>;
+ compatible = "fixed-clock";
+ clock-frequency = <1000000>;
+ clock-output-names = "rtcclk";
+};
+
+/* under /soc, in SoC-specific DT data */
+prci: clock-controller@10000000 {
+ compatible = "sifive,fu540-c000-prci";
+ reg = <0x0 0x10000000 0x0 0x1000>;
+ clocks = <&hfclk>, <&rtcclk>;
+ #clock-cells = <1>;
+};
--
2.20.1
