04.04.2019 12:17, Dmitry Osipenko пишет: > 25.03.2019 10:45, Joseph Lo пишет: >> Add the binding document for the external memory controller (EMC) which >> communicates with external LPDDR4 devices. It includes the bindings of >> the EMC node and the EMC table of different rates. >> >> To support high rates for LPDDR4, the EMC table must be trained before >> it can be used for runtime clock switching. It has been done by firmware >> and merged to the table that Linux kernel uses. For backward >> compatibility with the devices that had been launched on the market, like >> Shield and Jetson platforms, the bindings in the EMC table should remain >> the same. So the firmware can recognize them and merge the trained EMC >> table for the kernel. >> >> Based on the work of Peter De Schrijver <pdeschrijver@xxxxxxxxxx>. >> >> Signed-off-by: Joseph Lo <josephl@xxxxxxxxxx> >> --- >> .../nvidia,tegra210-emc.txt | 605 ++++++++++++++++++ >> 1 file changed, 605 insertions(+) >> create mode 100644 Documentation/devicetree/bindings/memory-controllers/nvidia,tegra210-emc.txt >> >> diff --git a/Documentation/devicetree/bindings/memory-controllers/nvidia,tegra210-emc.txt b/Documentation/devicetree/bindings/memory-controllers/nvidia,tegra210-emc.txt >> new file mode 100644 >> index 000000000000..1f6b6df6d37b >> --- /dev/null >> +++ b/Documentation/devicetree/bindings/memory-controllers/nvidia,tegra210-emc.txt >> @@ -0,0 +1,605 @@ >> +NVIDIA Tegra210 SoC EMC (external memory controller) >> +==================================================== >> + >> +Required properties : >> +- compatible : should be "nvidia,tegra21-emc", "nvidia,tegra210-emc". >> +- reg : physical base address and length of the controller's registers. >> +- clocks : phandles of the possible source clocks >> +- clock-names : names of the possible source clocks >> +- #address-cells : should be 1 >> +- #size-cells : should be 0 >> +- nvidia,memory-controller : phandle of the memory controller. >> +- nvidia,use-ram-code : boolean, indicates whether we should use RAM_CODE in >> + the register to find matching emc-table nodes >> + > > The "interrupts" property is missing. You could use the CLK handshake event to wait for the clock rate change completion instead of polling the register if you didn't rely on the downstream binding, see T20 driver for the example. BTW, I'm wondering if you're going to push other downstream bindings to upstream.. apparently EMC won't be the only binding that that could diverge from the upstream and then it's not obvious whether the locked-down variant of T210 is supportable by upstream at all. > One solution could be to use a multi-stage bootloader, where the last stage is an opensource part that will take the downstream binding and convert it into a proper one.
