From: Bai Ping <ping.bai@xxxxxxx>
The system counter (sys_ctr) is a programmable system counter
which provides a shared time base to the Cortex A15, A7, A53 etc cores.
It is intended for use in applications where the counter is always
powered on and supports multiple, unrelated clocks. The sys_ctr hardware
supports:
- 56-bit counter width (roll-over time greater than 40 years)
- compare frame(64-bit compare value) contains programmable interrupt
generation
Signed-off-by: Bai Ping <ping.bai@xxxxxxx>
---
change v1->v2:
- no change
change v2->v3:
- remove the clocksource, we only need to use this module for timer purpose,
so register it as clockevent is enough.
- use the timer_of_init to init the irq, clock, etc.
- remove some unnecessary comments.
---
drivers/clocksource/Kconfig | 7 ++
drivers/clocksource/Makefile | 1 +
drivers/clocksource/timer-imx-sysctr.c | 149 +++++++++++++++++++++++++++++++++
3 files changed, 157 insertions(+)
create mode 100644 drivers/clocksource/timer-imx-sysctr.c
diff --git a/drivers/clocksource/Kconfig b/drivers/clocksource/Kconfig
index 171502a..90cd908 100644
--- a/drivers/clocksource/Kconfig
+++ b/drivers/clocksource/Kconfig
@@ -598,6 +598,13 @@ config CLKSRC_IMX_TPM
Enable this option to use IMX Timer/PWM Module (TPM) timer as
clocksource.
+config TIMER_IMX_SYS_CTR
+ bool "i.MX system counter timer" if COMPILE_TEST
+ depends on ARCH_MXC
+ select TIMER_OF
+ help
+ Enable this option to use i.MX system counter timer for clockevent.
+
config CLKSRC_ST_LPC
bool "Low power clocksource found in the LPC" if COMPILE_TEST
select TIMER_OF if OF
diff --git a/drivers/clocksource/Makefile b/drivers/clocksource/Makefile
index be6e0fb..bc5ce50 100644
--- a/drivers/clocksource/Makefile
+++ b/drivers/clocksource/Makefile
@@ -73,6 +73,7 @@ obj-$(CONFIG_CLKSRC_MIPS_GIC) += mips-gic-timer.o
obj-$(CONFIG_CLKSRC_TANGO_XTAL) += timer-tango-xtal.o
obj-$(CONFIG_CLKSRC_IMX_GPT) += timer-imx-gpt.o
obj-$(CONFIG_CLKSRC_IMX_TPM) += timer-imx-tpm.o
+obj-$(CONFIG_TIMER_IMX_SYS_CTR) += timer-imx-sysctr.o
obj-$(CONFIG_ASM9260_TIMER) += asm9260_timer.o
obj-$(CONFIG_H8300_TMR8) += h8300_timer8.o
obj-$(CONFIG_H8300_TMR16) += h8300_timer16.o
diff --git a/drivers/clocksource/timer-imx-sysctr.c b/drivers/clocksource/timer-imx-sysctr.c
new file mode 100644
index 0000000..d3afc3b
--- /dev/null
+++ b/drivers/clocksource/timer-imx-sysctr.c
@@ -0,0 +1,149 @@
+// SPDX-License-Identifier: GPL-2.0+
+//
+// Copyright 2017-2019 NXP
+
+#include <linux/interrupt.h>
+#include <linux/clockchips.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
+
+#include "timer-of.h"
+
+#define CMP_OFFSET 0x10000
+
+#define CNTCV_LO 0x8
+#define CNTCV_HI 0xc
+#define CMPCV_LO (CMP_OFFSET + 0x20)
+#define CMPCV_HI (CMP_OFFSET + 0x24)
+#define CMPCR (CMP_OFFSET + 0x2c)
+
+#define SYS_CTR_EN 0x1
+#define SYS_CTR_IRQ_MASK 0x2
+
+static void __iomem *sys_ctr_base;
+
+static void sysctr_timer_enable(bool enable)
+{
+ u32 val;
+
+ val = readl(sys_ctr_base + CMPCR);
+ val &= ~SYS_CTR_EN;
+ if (enable)
+ val |= SYS_CTR_EN;
+
+ writel(val, sys_ctr_base + CMPCR);
+}
+
+static void sysctr_irq_acknowledge(void)
+{
+ /*
+ * clear the enable bit(EN =0) will clear
+ * the status bit(ISTAT = 0), then the interrupt
+ * signal will be negated(acknowledged).
+ */
+ sysctr_timer_enable(false);
+}
+
+static inline u64 sysctr_read_counter(void)
+{
+ u32 cnt_hi, tmp_hi, cnt_lo;
+
+ do {
+ cnt_hi = readl_relaxed(sys_ctr_base + CNTCV_HI);
+ cnt_lo = readl_relaxed(sys_ctr_base + CNTCV_LO);
+ tmp_hi = readl_relaxed(sys_ctr_base + CNTCV_HI);
+ } while (tmp_hi != cnt_hi);
+
+ return ((u64) cnt_hi << 32) | cnt_lo;
+}
+
+static int sysctr_set_next_event(unsigned long delta,
+ struct clock_event_device *evt)
+{
+ u32 cmp_hi, cmp_lo;
+ u64 next;
+
+ sysctr_timer_enable(false);
+
+ next = sysctr_read_counter();
+
+ next += delta;
+
+ cmp_hi = (next >> 32) & 0x00fffff;
+ cmp_lo = next & 0xffffffff;
+
+ writel_relaxed(cmp_hi, sys_ctr_base + CMPCV_HI);
+ writel_relaxed(cmp_lo, sys_ctr_base + CMPCV_LO);
+
+ sysctr_timer_enable(true);
+
+ return 0;
+}
+
+static int sysctr_set_state_oneshot(struct clock_event_device *evt)
+{
+ sysctr_timer_enable(true);
+
+ return 0;
+}
+
+static int sysctr_set_state_shutdown(struct clock_event_device *evt)
+{
+ sysctr_timer_enable(false);
+
+ return 0;
+}
+
+static irqreturn_t sysctr_timer_interrupt(int irq, void *dev_id)
+{
+ struct clock_event_device *evt = dev_id;
+
+ sysctr_irq_acknowledge();
+
+ evt->event_handler(evt);
+
+ return IRQ_HANDLED;
+}
+
+static struct timer_of to_sysctr = {
+ .flags = TIMER_OF_IRQ | TIMER_OF_CLOCK | TIMER_OF_BASE,
+ .clkevt = {
+ .name = "i.MX system counter timer",
+ .features = CLOCK_EVT_FEAT_ONESHOT | CLOCK_EVT_FEAT_DYNIRQ,
+ .set_state_oneshot = sysctr_set_state_oneshot,
+ .set_next_event = sysctr_set_next_event,
+ .set_state_shutdown = sysctr_set_state_shutdown,
+ .rating = 200,
+ },
+ .of_irq = {
+ .handler = sysctr_timer_interrupt,
+ .flags = IRQF_TIMER | IRQF_IRQPOLL,
+ },
+ .of_clk = {
+ .name = "per",
+ },
+};
+
+static void __init sysctr_clockevent_init(void)
+{
+ to_sysctr.clkevt.cpumask = cpumask_of(0);
+
+ clockevents_config_and_register(&to_sysctr.clkevt, timer_of_rate(&to_sysctr),
+ 0xff, 0x7fffffff);
+}
+
+static int __init sysctr_timer_init(struct device_node *np)
+{
+ int ret = 0;
+
+ ret = timer_of_init(np, &to_sysctr);
+ if (ret)
+ return ret;
+
+ sys_ctr_base = timer_of_base(&to_sysctr);
+
+ sysctr_clockevent_init();
+
+ return 0;
+}
+TIMER_OF_DECLARE(sysctr_timer, "nxp,sysctr-timer", sysctr_timer_init);
--
1.9.1
