On Mon, Mar 25, 2019 at 11:55:50AM +0100, Geert Uytterhoeven wrote: > Hi Simon, > > On Fri, Mar 22, 2019 at 11:23 AM Simon Horman <horms@xxxxxxxxxxxx> wrote: > > On Wed, Mar 20, 2019 at 08:44:09PM +0100, Geert Uytterhoeven wrote: > > > Enable the I2C bus, and add the following devices: > > > - Two CAT9554 port expanders (8 GPIOs, interrupt not wired by > > > default), > > > - R1EX24016ASAS0A EEPROM. > > > > > > The bus also contains a MAX9856 Audio Codec, which is not yet supported. > > > > > > All devices (incl. the audio codec) are documented to support an I2C bus > > > running at 400 kHz. > > > > > > Pinctrl is based on the RZ/A BSP. > > > > > > Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > > > --- > > > Pending acceptance of the DT binding patches documenting the > > > "onnn,cat9554" and "renesas,r1ex24016" compatible values. > > > > Thanks. > > > > I'm marking this series as deferred pending acceptance of the bindings. > > Please repost or ping me once that has happened. > > next-20190325 has: > > d333bad1f6f3e0df dt-bindings: at24: add Renesas R1EX24016 > 5c9f8cfe3cb67dcb dt-bindings: gpio: pca953x: Document onnn,cat9554 Thanks, applied for v5.2.
