The 'ingenic,bch-controller' property is now deprecated and the
'ecc-engine' property should be used instead.
Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
Notes:
v5: New patch
v6: No change
Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
index 5a45cc54f46d..c02259353327 100644
--- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
@@ -14,7 +14,7 @@ Required NAND controller device properties:
an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).
Optional NAND controller device properties:
-- ingenic,bch-controller: To make use of the hardware ECC controller, this
+- ecc-engine: To make use of the hardware ECC controller, this
property must contain a phandle for the ECC controller node. The required
properties for this node are described below. If this is not specified,
software ECC will be used instead.
@@ -48,7 +48,7 @@ nemc: nemc@13410000 {
#address-cells = <1>;
#size-cells = <0>;
- ingenic,bch-controller = <&bch>;
+ ecc-engine = <&bch>;
nand@1 {
reg = <1>;
--
2.11.0
