Hi,
On 11-03-19 06:33, Chunfeng Yun wrote:
Hi,
On Fri, 2019-03-08 at 13:07 +0100, Hans de Goede wrote:
Hi,
On 08-03-19 07:13, Chunfeng Yun wrote:
Add id-gpios, vbus-gpios, vbus-supply and pinctrl properties for
usb-b-connector
Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
---
.../devicetree/bindings/connector/usb-connector.txt | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/Documentation/devicetree/bindings/connector/usb-connector.txt b/Documentation/devicetree/bindings/connector/usb-connector.txt
index a9a2f2fc44f2..7a07b0f4f973 100644
--- a/Documentation/devicetree/bindings/connector/usb-connector.txt
+++ b/Documentation/devicetree/bindings/connector/usb-connector.txt
@@ -17,6 +17,16 @@ Optional properties:
- self-powered: Set this property if the usb device that has its own power
source.
+Optional properties for usb-b-connector:
+- id-gpios: gpio for USB ID pin.
What about boards where the ID pin is *not* connected to a GPIO,
but e.g. to a special pin on the PMIC which can also detect
an ACA adapter ? Currently this case is handled by extcon
drivers, but we have no way to set e.g. vbus-supply for the
connector. Maybe in this case the usb-connector node should
be a child of the PMIC node ?
Yes, it would be, PMIC is in charger of detecting the status of ID pin
Ok, then I think this should be documented too.
And in many cases there also is a mux to switch the datalines
between the host and device(gadget) controllers, how should
that be described in this model? See the new usb-role-switch
code under drivers/usb/roles
In some cases the mux is controlled through a gpio, so we
may want to add a "mux-gpios" here in which case we also
need to define what 0/1 means.
I'm not sure, the mux seems not belong to this connector,
and may need another driver to register usb-role-switch,
similar to:
[v2,2/2] usb: typec: add typec switch via GPIO control
https://patchwork.kernel.org/patch/10834327/
Right the mux/role-switch will need a driver, but the "owner"
of the usb_connector, e.g. the PMIC or the owner of the
id GPIO pin needs to know which device is the role-switch so
that it can set the role correctly based on the id-pin.
Your binding already contains Vbus info, allowing the owner
of the usb_connector to enable/disable Vbus based on the id-pin,
but the owner will also be responsible for setting the role-switch.
Note we cannot simply assume there will be only one role-switch,
we really need some link from the usb_connector to the role-switch
(or if it is a GPIO driven role-switch simply a role-switch-gpios
member in the usb_connector).
Regards,
Hans
