Describe properly the MMC0 node (with attached embedded MMC memory) on
Arndale Node by:
1. Adding the regulator for host interface (although it still has to be
"always-on" so the board with Linaro U-Boot will boot;
2. Using "non-removable" instead of "broken-cd" property, because eMMC
is embedded into the board;
3. Adding support for HS200 v1.8 to indicate support in host controller
although this has no practical effect (embedded memory does not
support it).
Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
arch/arm/boot/dts/exynos5420-arndale-octa.dts | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/exynos5420-arndale-octa.dts b/arch/arm/boot/dts/exynos5420-arndale-octa.dts
index 96a0eb73a99b..56a42c68bc39 100644
--- a/arch/arm/boot/dts/exynos5420-arndale-octa.dts
+++ b/arch/arm/boot/dts/exynos5420-arndale-octa.dts
@@ -378,6 +378,12 @@
regulator-name = "PVDD_APIO_MMCON_1V8";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
+ /*
+ * Must be always on, even though there is
+ * a consumer (mmc_0). Otherwise the board
+ * does not reboot with vendor U-Boot
+ * (Linaro for Arndale Octa, v2012.07).
+ */
regulator-always-on;
};
@@ -685,7 +691,7 @@
&mmc_0 {
status = "okay";
- broken-cd;
+ non-removable;
card-detect-delay = <200>;
samsung,dw-mshc-ciu-div = <3>;
samsung,dw-mshc-sdr-timing = <0 4>;
@@ -693,8 +699,10 @@
pinctrl-names = "default";
pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8>;
vmmc-supply = <&ldo10_reg>;
+ vqmmc-supply = <&ldo3_reg>;
bus-width = <8>;
cap-mmc-highspeed;
+ mmc-hs200-1_8v;
};
&mmc_2 {
--
2.17.1
