Re: [PATCH] ARM: dts: am437x-gp-evm: Do not reset gpio5

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 03/21/2014 12:52 AM, Felipe Balbi wrote:
On Fri, Mar 21, 2014 at 10:50:13AM +0530, Lokesh Vutla wrote:
From: Dave Gerlach <d-gerlach@xxxxxx>

Do not reset GPIO5 at boot-up because GPIO5_7 is used
on AM437x GP-EVM to control VTT regulators on DDR3.
Without this some GP-EVM boards will fail to boot because
of DDR3 corruption.

Reported-by: Nishanth Menon <nm@xxxxxx>
Tested-by: Nishanth Menon <nm@xxxxxx>
Signed-off-by: Dave Gerlach <d-gerlach@xxxxxx>
Signed-off-by: Lokesh Vutla <lokeshvutla@xxxxxx>

every now and again we see a patch like this because yet another board
is using a GPIO to toggle DDR regulators.

Instead of constantly patching things like this, how about we try
something like below (build-tested only):

Why should we change all of them? Is it correct to leave every single GPIO at the mercy of the bootloader in every situation? The reason we see these patches only every now and again is because it's a special case that should be handled only for that situation. I also don't think it makes sense to make gpio's a unique case that never gets reset while every other IP does by default.

Regards,
Dave


diff --git a/arch/arm/mach-omap2/omap_hwmod.c b/arch/arm/mach-omap2/omap_hwmod.c
index 1f33f5d..f5962ff 100644
--- a/arch/arm/mach-omap2/omap_hwmod.c
+++ b/arch/arm/mach-omap2/omap_hwmod.c
@@ -2610,6 +2610,10 @@ static int __init _setup_reset(struct omap_hwmod *oh)
  	if (oh->flags & HWMOD_EXT_OPT_MAIN_CLK)
  		return -EPERM;

+	/* NEVER reset GPIO blocks */
+	if (strncmp(oh->name, "gpio", 4) == 0)
+		return 0;
+
  	if (oh->rst_lines_cnt == 0) {
  		r = _enable(oh);
  		if (r) {
diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 4243190..ce8b53a 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -1130,6 +1130,29 @@ static void omap_gpio_chip_init(struct gpio_bank *bank)

  static const struct of_device_id omap_gpio_match[];

+static void omap_gpio_init_context(struct gpio_bank *p)
+{
+	struct omap_gpio_reg_offs *regs = p->regs;
+	void __iomem *base = p->base;
+
+	p->context.ctrl		= readl_relaxed(base + regs->ctrl);
+	p->context.oe		= readl_relaxed(base + regs->direction);
+	p->context.wake_en	= readl_relaxed(base + regs->wkup_en);
+	p->context.leveldetect0	= readl_relaxed(base + regs->leveldetect0);
+	p->context.leveldetect1	= readl_relaxed(base + regs->leveldetect1);
+	p->context.risingdetect	= readl_relaxed(base + regs->risingdetect);
+	p->context.fallingdetect = readl_relaxed(base + regs->fallingdetect);
+	p->context.irqenable1	= readl_relaxed(base + regs->irqenable);
+	p->context.irqenable2	= readl_relaxed(base + regs->irqenable2);
+
+	if (regs->set_dataout && p->regs->clr_dataout)
+		p->context.dataout = readl_relaxed(base + regs->set_dataout);
+	else
+		p->context.dataout = readl_relaxed(base + regs->dataout);
+
+	p->context_valid = true;
+}
+
  static int omap_gpio_probe(struct platform_device *pdev)
  {
  	struct device *dev = &pdev->dev;
@@ -1246,6 +1269,7 @@ static int omap_gpio_probe(struct platform_device *pdev)
  	omap_gpio_mod_init(bank);
  	omap_gpio_chip_init(bank);
  	omap_gpio_show_rev(bank);
+	omap_gpio_init_context(bank);

  	pm_runtime_put(bank->dev);

@@ -1325,8 +1349,6 @@ update_gpio_context_count:
  	return 0;
  }

-static void omap_gpio_init_context(struct gpio_bank *p);
-
  static int omap_gpio_runtime_resume(struct device *dev)
  {
  	struct platform_device *pdev = to_platform_device(dev);
@@ -1466,29 +1488,6 @@ void omap2_gpio_resume_after_idle(void)
  }

  #if defined(CONFIG_PM_RUNTIME)
-static void omap_gpio_init_context(struct gpio_bank *p)
-{
-	struct omap_gpio_reg_offs *regs = p->regs;
-	void __iomem *base = p->base;
-
-	p->context.ctrl		= readl_relaxed(base + regs->ctrl);
-	p->context.oe		= readl_relaxed(base + regs->direction);
-	p->context.wake_en	= readl_relaxed(base + regs->wkup_en);
-	p->context.leveldetect0	= readl_relaxed(base + regs->leveldetect0);
-	p->context.leveldetect1	= readl_relaxed(base + regs->leveldetect1);
-	p->context.risingdetect	= readl_relaxed(base + regs->risingdetect);
-	p->context.fallingdetect = readl_relaxed(base + regs->fallingdetect);
-	p->context.irqenable1	= readl_relaxed(base + regs->irqenable);
-	p->context.irqenable2	= readl_relaxed(base + regs->irqenable2);
-
-	if (regs->set_dataout && p->regs->clr_dataout)
-		p->context.dataout = readl_relaxed(base + regs->set_dataout);
-	else
-		p->context.dataout = readl_relaxed(base + regs->dataout);
-
-	p->context_valid = true;
-}
-
  static void omap_gpio_restore_context(struct gpio_bank *bank)
  {
  	writel_relaxed(bank->context.wake_en,

Then, we can even remove ti,no-reset flag from all GPIO DT nodes.


--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux